Why You Should Focus On Improving Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a bit old but it's still striking. It's not the most luxurious car in its class, but it's a relaxing and civilised drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will aid in solving the issue whether it is intermittent, or constant.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to large amounts of water.
You'll also want to make sure that the fob is completely dry before opening it up and re-using it. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) This is a further indicator that it is submerged.
A wet circuit can cause the battery's power to be depleted or even explode. If you are able to get the 308 keyfob from the water and turn it upside up and shake as much water as you can prior to opening the casing. After you open it, take out the battery and clean the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might be unable to function could be due to a dead battery for your coin problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of the above is the problem you can restart the system by removing the 12 voltage battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to getting in. This feature is very beneficial, especially in the cold winter months. However, it is possible that the remote start system ceases functioning due to a variety of reasons, like an unresponsive coin battery.
The coin-shaped battery within the key fob may last between two and four years depending on how often it's utilized, the place it was purchased and how it is utilized. TheKeyLab -by date will be printed on the packaging or in the user's manual.
If the key fob is not functioning after exposure to water that is clean and you want to take the battery off, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have fried the chip. You will need to replace it.
If you're unsure whether the battery is in good condition you can check its voltage using a multimeter that is connected to both the plus and minus terminals. The voltage should be between 12 to 13 volts, but if it's lower, the battery must be replaced. If you want to, you can try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should now begin.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible that your receiver module has discovered a problem. It's the part that sends an indication to the car when your key fob is activated, it also acts as an immobiliser, and stops it from starting until the correct key is used.
This could be due to a variety of factors including water damage or simply aging. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water It could be because the keyfob was exposed to it. In this instance it is necessary to take off the battery and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the issue continues to persist, it is recommended to visit an area Peugeot expert or locksmith. They can employ an instrument for diagnosing to identify the issue and repair it.
It can be stressful to lose your Peugeot car key. A reputable auto locksmith can resolve the issue within minutes. They can program your vehicle and cut a new working key for you. Click here to find locksmiths near you.
Electronic chip that is malfunctioning
The electronic chip inside the Peugeot 308 key fob is a very important part of the remote control system. If the chip is damaged, you could have problems starting your car or receive a message saying "anti-theft". If this occurs, the only option to fix the problem is to purchase a new key. Auto locksmiths who are professionals can provide this fastest possible time.
The chip inside the chip of your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob has been exposed to soapy water, you should clean it immediately. You can wipe the electronic component using paper towels soaked with isopropyl Alcohol. The battery must then be allowed to completely dry.
Sometimes, a key fob can cease to function due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. This could be due to problems with the environment or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you encounter this problem.
The Peugeot 207/308 key fob is extremely delicate and requires care. You shouldn't drop it or throw it around. If you lose it, try to find it as quickly as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Make sure you disconnect the negative cable first, then the positive.
