Why Seat Keys Replacement Is A Lot A Lot More Hazardous Than You Thought
Seat Alhambra Key Problems
Seat's Jumbo MPV family is among the top in its class when it comes down to resale value. And with a brand new model now on sale, it's better than ever.
There are a number of reasons why the key fob might not work correctly, including dead battery, damage to the receiver module, water issues, or signal interference. This article will guide you through the steps to make sure it works.
Water Damage
If your key fob for the seat alhambra survives washing cycles or dip in the ocean or a pool then it has a waterproof chip. But, read more shouldn't do this often, as prolonged exposure to water increases chances of the key fob being damaged. If the key fob ceases to functioning after exposure to clean water from the tap or rain, just take out the battery, clean the electronic component with a paper towel and allow it to dry completely before putting the battery back in. If the key fob was exposed to soapy or salty water it is recommended you clean the chip with isopropyl or electronic cleaner.
Faulty Receiver Module
If you've tried an entirely new battery for your button and the key fob cannot be locked or unlocked, it's likely that the receiver module has discovered a problem. It's a simple and affordable fix. You can disconnect the battery that is 12 volts for a couple of minutes (first remove the negative cable, then press the horn numerous times) to remove any remaining electricity. Then reconnect it in reverse. positive cable first and then negative.
ESP Warning Light - If the ESP warning light flashes, it is normal and indicates that the car is travelling on terrain in which the traction between the road surface and tyres aren't as good, such as gravel, snow or lots of surface water. If the ESP light is constantly flashing, it is a sign there is a problem with the system. It is possible to identify the problem by using an iCarsoft i908 seat OBD code reader kit. It will provide you with a the full description of the problem.
Dead Coin Battery
One of the most frequent reasons for the seat alhambra keys to stop working is a dead battery. The key fob is powered by a small button-cell battery. Replace it with a brand new battery with the same size, voltage and specifications as the original. If you're replacing the battery ensure that you remove all metal retaining clips from the back of the key fob. Also make sure that the contacts are free of corrosion.
If the key fob was exposed to water (such as soapy tap water) it is recommended to remove and clean the chip using an electronic cleaner or isopropyl ethanol before installing a brand new battery. The chip is sensitive to moisture and may be permanently damaged. If the key fob still not working after replacing the battery, it might be necessary to replace the entire key fob.
Faulty Receiver Module
If your key fob has stopped working after you replaced the battery, but it did not help, or it suddenly stopped working out of the blue the receiver module might have developed an issue. The receiver module receives the radio frequency signals from your remote keyfob and transforms them into electrical signals that are then followed by other modules inside the car.
If the receiver module is damaged, it will not accept any commands from your remote key fob. In this scenario, a dealer will need to reprogramme your key fob as well as install an additional receiver.
The key fob is fitted with rubber seals that stop water from getting into the electronic chip inside. However, if you submerge your key fob into salted or soapy ocean water, the chips inside could be damaged. If your key fob doesn't work, you can try cleaning the chip using isopropyl or electronic cleaner.
If the keys have been paired but the receiver module has developed a fault, you can try rebooting all of the onboard electronics by disconnecting the battery at 12 volts for a few minutes. Connect the battery in reverse (negative cable to positive first). This will reset all electronic components onboard and restore their functionality.
Faulty electronic chip
The key fob contains an electronic chip that transmits a signal to the receiver module whenever the key is used. If this signal does not coincide with the one stored by the car the immobilizer will shut down the engine and stop the vehicle from beginning. If the key fob you purchased does not function and you are not able to reprogram it, it could be because of an incompatible microchip.
The chip inside the key fob may have to be replaced in order to make it function properly. The best way to do this is by removing the key from its housing and using a pin or needle to connect with each of the clips made of metal. If they are corroded or broken, you will need to replace them to allow the remote control to work. Make sure that the replacement batteries have the same size, voltage and specifications as the original.
The Seat Alhambra is a popular and well-designed car however, just like any other vehicle it can occasionally experience issues with particular parts or equipment. There have been reports of problems with the auto climate control system. It is prone to fail and get stuck in a specific setting. In the same way, the infotainment system has also been found to malfunction and cause freeze screens.