Why Peugeot Keys Will Be Your Next Big Obsession
Peugeot 208 Key Replacement
It is best to delegate the replacement of Peugeot keys for 208 to auto locksmiths that have the necessary equipment and technical expertise. They can create and program keys faster and cheaper than dealers.
If the key fob has stopped locking or unlocking your doors, it could be due to a dead coin battery. There are also other reasons that the key could be malfunctioning.
Dead Coin Battery
A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as preventing it from starting the engine. In this situation you'll need make use of the alternative method for starting found in your vehicle's owner's manual.
The spark plugs may also be worn out. The spark plugs are responsible for sparking the fuel which starts the engine. They are only able to last for a short time. They'll eventually break down if they're not used enough.
There is a simple solution to this issue. The best way to solve this issue is to check the voltage of your car battery with a multimeter. If the voltage is below 11,5 volts, it's the time to replace it. It is also necessary to clean the contacts of the battery in the event that it is damaged by corrosion. peugeot remote key replacement www.g28carkeys.co.uk can be accomplished by taking off the rubber covers from the two terminals on the battery and then using a wirebrush, you can remove any corroded parts of the battery. Then, you should connect the cables for the positive and negative poles.
Water Damage
If your 208 doesn't start and the battery has not gone flat, you should look at the spark plugs. It could be that they are simply too dirty and don't spark. The spark plugs can be cleaned in an workshop.
Peugeot cars use a key with a transponder compatible with the immobiliser. This ensures that only a valid key is able to turn the engine. If the chip inside the Peugeot key is damaged, it won't transmit the proper signal to the vehicle.
This is a typical issue that can be caused by water damage. This is a frequent issue in more cold climates where the car is exposed to snow or rain. In this case, you need to contact an experienced locksmith who has the tools and equipment required to change the key's programming. They will also have all the latest technology and machinery required to make a Peugeot smart key. The process should take no more than 15 minutes.
Faulty Battery Contacts
Peugeot replaced the transponder chips with a new version that makes use of electronic components mounted on a circuitboard. The new system is great in its initial state, but the circuit boards deteriorate over time and cease to function properly.
This could prevent the immobiliser from working, so your vehicle will not start. If this happens, it's a good idea to seek out a Peugeot specialist or locksmith.
Another issue that is common is when the battery in the key fob begins to fail, which causes the blade of the key to stop from entering the lock. A car locksmith can replace the battery and cut a fresh blade for you, it's normally a quick fix.
Faulty Receiver Module
If your Peugeot key fob was not working after dropping it on the floor, or being exposed to a sudden rain or accidentally washing it may be due to a defective receiver module. The receiver module is responsible for transmitting radio frequency to the onboard computer which regulates the central locking system of your Peugeot vehicle.
The key fob itself has rubber seals that prevent water from reaching the chip inside. However prolonged exposure to water can be able to penetrate these seals and cause damage to the chip. The high salt content in the ocean water or pool could cause damage to the key fob, especially if it is submerged.
If your Peugeot spare key fob isn't working, you'll need to have the module replaced. This is only performed by a professional auto locksmith or Peugeot specialist. Peugeot keys, unlike other cars, are secured by an immobilizer system. This requires the correct programming to allow the car to start. This is the reason why you should only choose a reputable Peugeot locksmith for the job of creating and programming an appropriate replacement.
Faulty On-Board Computer
The computer on the board of your Peugeot is responsible for a number of the systems inside the car, from airbags to power windows. If something goes wrong with these systems, it will usually display a code that indicates the issue. This code will be saved within the system until the issue is resolved. In most cases, this will require replacing the onboard computer.
The most typical reason for the warning light for the airbag to flash is corrosion or loose connections in the sensor. This can occur due to wear and tear, ageing or exposure to moisture and salt. This issue must be addressed as soon you can, since an airbag that is malfunctioning could pose a risk in the event of an accident.
If your Peugeot is showing a card not detected error, then the key battery inside the key fob could be dead or weak. This will stop the key fob sending a signal to deactivate the vehicle's immobilizer. You can test this by pressing the unlock button on the key fob and then attempting to start your car. If this doesn't work it is likely that the battery is in need of replacement.