Why One Printer Percentage Cannot Correct Two Unequal Axes
SewloreTwo measurements describe two directions
A printer percentage usually multiplies every distance by one number. That is useful when the whole page has the same proportional error. It cannot independently choose one multiplier for the horizontal direction and another for the vertical direction. Checking both sides of a reference shape therefore reveals information that a single measurement cannot provide.
Consider an invented example: a PDF labels a square as 100 mm wide and 100 mm high. A paper reading is recorded as 102 mm wide and 99 mm high. These numbers are a mathematical scenario, not a printer test performed by Sewlore. The width scale is 102%; the height scale is 99%. Their signed errors are +2% and -1%, respectively.
Write the required multipliers
Let k be a uniform multiplier. The corrected dimensions would be 102k and 99k millimetres. To obtain the labelled width, the equation is 102k = 100, giving k = 100/102 = 50/51, approximately 0.980392. To obtain the labelled height, the equation is 99k = 100, giving k = 100/99, approximately 1.010101.
Those are different numbers. The width needs a reduction while the height needs an increase. Choosing one percentage cannot satisfy both equations exactly. In general, a uniform correction exists only when target width divided by observed width equals target height divided by observed height. Equal millimetre differences alone are not enough when the target dimensions differ.
For a hypothetical rectangular reference, a 120 x80 mm target observed as 118.8 x79.2 mm has the same 0.99 ratio on each axis. Its millimetre differences are unequal, but its required multipliers are equal. The comparison must preserve each target dimension, not simply compare the raw shortfalls.
Fixing one axis leaves an error in the other
If the width-based multiplier 50/51 is used, the width becomes 100 mm, but the height becomes 99 x 50/51 = 97.0588 mm. If the height-based multiplier 100/99 is used, the height becomes 100 mm, but the width becomes 102 x 100/99 = 103.0303 mm. These calculated results explain why repeatedly chasing one side can fail.
An average also hides the directional disagreement. The original mean side length is 100.5 mm. Multiplying by 100/100.5 gives sides of approximately 101.4925 mm and 98.5075 mm. Their average is exactly 100 mm, yet neither side is correct. One summary number has discarded the distinction we need to preserve.
Compare an equal-scale case
Now imagine both sides read 96 mm for the same 100 mm target. Both equations require k = 100/96 = 25/24. Under a perfectly uniform mathematical model, that multiplier makes both sides 100 mm. Written as a percentage relative to the current scale, it is about 104.1667%. It is not simply 104%: adding the observed 4% shortfall is different from dividing by the observed ratio.
Keep the model separate from a printing decision
The arithmetic assumes a uniform response to a changed setting. It does not identify a printer fault, validate a ruler reading, or prove that a viewer will apply the requested value. Follow the actual pattern's instructions, check the correct PDF and paper format, examine scaling controls and complete reference marks, then print and measure another test page before the full pattern.
Record the original target, units, measured width and measured height. Keep each axis visible rather than replacing the pair with an average. A matching reference shape still does not establish garment fit or show that every assembly mark and page edge is complete. Use the pattern's instructions to decide what else must be inspected.
Compare the two measurements with Sewlore's PDF Pattern Print Scale Checker. The checker reports the measurements entered on each axis; it does not resize a PDF or establish why a printer changed its scale.
Prepared by Sewlore with AI-assisted writing. Numerical examples are hypothetical; no physical testing was performed.