What The 10 Most Stupid Peugeot 308 Key Fob Failures Of All Time Could Have Been Prevented
Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little however, it's still eye-catching. It's not the most luxurious car in its class, but it is a pleasant and peaceful drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is intermittent or constant these tips will assist.
Water Damage
When you accidentally leave your key fob in a pool or splash it with water while kayaking, swimming canoeing, rafting or canyoning, it's most likely to suffer water damage. The best way to avoid this from happening is to keep it in a dry container when you're outside or performing things where the fob might be exposed to large amounts of water.
You'll also need to make sure that the fob is completely dry prior to opening it and using it again. If you notice any odors emanating from the fob like an industrial liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.
A circuit that is wet can cause the battery's energy to drain or even explode. If you're able to fish your 308 key fob out of the water body it was stuck in it, flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then wipe the circuit board down using a cotton swab which is dipped in 90 percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead coin cell battery or receiver module issue signal interference or a damaged chip. If none of these is the problem, you can try resetting the system by removing the battery that is 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the car prior to entering. www.g28carkeys.co.uk is extremely beneficial, especially during cold winter months. Remote start systems can be stopped for a variety of reasons, such as an inactive coin-battery.
The coin-shaped battery that is within the key fob may last between two and four years based on how frequently it is used, the location it was purchased, and the way it is utilized. Its use-by date is typically found on the packaging or listed in the instruction manual.
If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it could have caused the chip to be damaged. It is recommended to replace it.
If you're unsure if the battery is faulty you can check its voltage with a multimeter set to your car's voltage range and connected to the plus and minus terminals. If the voltage is less than 12-13 volts then you must replace the battery. You can also try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should now begin.
Faulty Receiver Module
If you don't get the "Key Detected" you might find that your receiver module is faulty. It is the part which sends out a signal when your key fob goes off. It also functions as an alarm and blocks the car from starting if you don't have the correct key.
This can be due to many causes, such as water damage or just the aging process. If the chip inside your Peugeot 308 keyfob is damaged due to dirty tap water It could be because the keyfob was contaminated with it. In this instance, you'll need to take it out and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry you can put the battery back into the battery and try again.
If the issue continues to persist, it is a good idea that you visit an area Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the problem and repair it.
The loss of your Peugeot car keys could be an extremely stressful experience. However, a reputable auto locksmith can resolve the issue in only a few minutes. They can cut a brand new key and program it to your vehicle, ensuring you're to the road in the shortest amount of time. Click here to locate a locksmith in your area.
Electronic chip malfunctions
The electronic chip inside the Peugeot 308 key fob plays a vital role in the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying "anti-theft". If this happens, the only way to fix the problem is to purchase a new key. Auto locksmiths with experience are able to provide this service in the shortest time.
The chip inside the key fob of your Peugeot 308 may fail due to many reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it needs to be cleaned as soon as possible. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should then be allowed to dry completely.
Radio interference can cause the key fob to cease working. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by bad weather or objects in the vicinity of the vehicle. If you encounter this issue it is recommended to visit a Peugeot dealership.
The Peugeot key fob 207/308 is extremely delicate and requires extra care. It should not be dropped or throw it around. If you lose something, try to locate it as quickly as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Unplug the negative cable prior to the positive.