What NOT To Do Within The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be a bit old but it's striking. It's not the most luxurious car in its class, but it is an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is constant or intermittent the following suggestions should assist.
Water Damage
If you accidentally drop your key fob in the puddle, or it gets wet while kayaking canoeing or rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outside or perform activities that expose it to a lot of water.
You'll also need to make sure that the fob is dry before opening it up and using it again. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's submerged.
A circuit board that's damp can cause the battery to discharge its energy or even explode. If you can pull your 308 keyfob out of the water, turn the button side up and shake as much water as you can before opening the casing. Remove the battery, then wipe the circuit board clean with a cotton swab that is dipped in 90 percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not work include a dead battery in the coin-cell or receiver module malfunction, signal interference or a defective chip. If none of these are the reason you can reset the system by disconnecting the 12 volt battery from your vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the vehicle before they enter. This feature is very useful, especially in the cold winter months. However, it is possible that the remote start system stops operating due to a range of reasons, like the battery in the coin is dead.
The coin-shaped battery that is inside the key fob will last between two and four years depending on the frequency with which it is utilized, the place it was purchased, and the way it is used. Its use-by date is typically printed on the packaging or written in the manual.
If the key fob stopped working after being exposed to clean tapwater, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. If you expose it to salty or soapy water, the chip could be fried and you will need to replace the key fob in total.
If you're not certain the battery is defective you can check its voltage using an instrument set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be between 12-13 volts but if it is lower, the battery must be replaced. You can also try to reset your on-board computer by disconnecting the 12 volt battery for a short period of time, and reconnecting it in reverse order (positive cable first, then negative). The engine should start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has developed a fault. It's the part that transmits an indication to the car when your key fob is activated which also acts as an immobiliser, and stops it from starting until the correct key is present.
This could result from a variety of reasons, including water damage or simply the aging process. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was contaminated with it. In this instance you'll need to remove the device apart and clean it thoroughly using isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.
If the issue persists, it's probably a good idea to visit an area Peugeot specialist or locksmith. They can employ a diagnostic tool in order to identify the issue and then fix it.
It can be a stressful experience to lose your Peugeot car key. peugeot 207 key fob qualified auto locksmith will be able to solve the problem within minutes. They can cut a brand new key and programme it to your vehicle, so you're out on the road as quickly as possible. Click here to find the nearest locksmith.
Faulty Electronic Chip
The electronic chip inside your Peugeot 308 key fob is a very important part of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". If this occurs, the only option to fix the issue is to get a new key. Fortunately, professional auto locksmiths can provide the service in the shortest amount of time.
The chip inside the key fob of your Peugeot 308 could be damaged due to different reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, clean it immediately. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. The battery should then be allowed to dry completely.
Sometimes the key fob may not function due to radio interference. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It can also be caused by weather conditions or objects in the vicinity. It is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is very delicate and requires special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.