What NOT To Do In The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be a little old however it's still appealing. It's not the most luxurious car in its class, but it is a pleasant and peaceful drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following tips will aid.
Water Damage
If you accidentally drop your key fob in a puddle or it is wet while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outside or perform activities that could expose it to excessive water.
You should also ensure that the fob is completely dry before opening it up and using it again. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it's been submerged.
A circuit board that is wet could cause the battery to dump its charge or even explode. If you're able, if you can, pull the 308 key fob of the water in which it got stuck in it, flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then wipe the circuit board down using a cotton swab that has been dipped into 90-percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery or receiver module issue, signal interference or a defective chip. If none of the above are the issue, try resetting the system by removing the battery that is 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system which allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely useful particularly during the cold winter months. However, sometimes the remote stop system stops functioning due to a variety of reasons, such as a dead coin battery.
The coin-shaped battery located inside the key fob can last between two and four years, based on the frequency with which it is utilized, the place it was purchased, and the way it is utilized. The date for use-by will be displayed on the packaging or marked in the user's manual.
If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, clean the chip using a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. In case of exposure to soapy or salty water, the chip might be damaged and you'll have to replace the key fob completely.
If you're unsure whether the battery is defective You can test its voltage using a multimeter attached to both the plus and minus terminals. The voltage should be between 12-13 volts, however, if it reads lower, the battery should be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). www.g28carkeys.co.uk should then start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has discovered a problem. It's the component which sends out the signal when your key fob activates. It also acts as an alarm and prevents the car from starting if it doesn't have the correct key.
This can be due to various causes, such as water damage or just aging. If your Peugeot 308 key fob was exposed to dirty tap water, like the electronic chip located inside the device will be damaged. In this case you'll have to take it apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue persists, it is a good idea to consult an area Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the issue and fix it.
It can be stressful to lose your Peugeot car key. A qualified auto locksmith will be able to solve the issue in minutes. They can cut a new key and program it to your vehicle, ensuring you're to the road as fast as you can. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip inside your Peugeot 308 key fob is a very crucial component of the remote control system. If it gets damaged, your car might not start or receive a message stating "anti-theft active". If this happens, the only way to fix the issue is to purchase a new key. Professional auto locksmiths are able to provide this fastest possible time.
The chip inside your Peugeot 308's key fob may fail due to a variety of reasons, including sweat, water damage, or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned promptly. You can make use of a towel and isopropyl ethanol to clean the electronic component. The battery must then be allowed to completely dry.
Radio interference can cause a key fob's functionality to cease. This can be caused when other devices operate on the same frequencies as your Peugeot keyfob. This could be due to poor conditions or objects within the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer in the event of this problem.
The Peugeot 207/308 Key Fob is very delicate and requires particular care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as soon as possible. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Unplug the negative cable prior to the positive.