Tips on how to Care for A Printhead
Printhead Life Span
The average life span for a dot matrix printhead is about 200 million characters. Assuming if we print a full web page of A4 paper (60 lines with 80 characters per line), it'll print a total of 4800 characters per web page. That signifies the printhead is capable to print a total of 4200 pages prior to it will begin to fail. Keep in mind that not each web page consists of 4800 printed characters. So the actual pages before it fails is greater than 4200 pages. Get far more details about tsc barcode printer
Ways to care for a print head
1. Usually do not use a low good quality printer ribbon. It might be cheap but it will certainly damage your printhead inside a extended run. An original ribbon is impregnated with unique ink and oil, which will lubricate the printhead pin wires for the duration of printing plus the textile material in the ribbon are created by special technologies exactly where else the compatibles doesn't have excellent control more than the type of textile, ink and oil.
2. Know when to change your print ribbon.
When printing starts, the quantity of ink and lubricant will retain decreasing and high-quality of printing will gradually decline. When quality reduces below a certain limit, the ribbon will commence to wear (to threads). When this takes place, the fine textile fibers mixes with cellulose filaments in the paper and forms a dark gray dust. This signals the time for you to modify to a new ribbon. Otherwise, the dust residue will clog the printhead and will lower the life span of it. Please do not reuse or re-ink old ribbon!
3. Printhead positioning and gap.
Attempt to look to get a lever for printhead positioning. Normally for Epson printers, it is situated at the suitable side on the printer, marked -1, 0, 1, 2, 3, 4, 5, 6 or 7. As for Panasonic printers, it's commonly positioned in the left side from the printer, marked Head Gap 1, 2, 3, 4, 5 or 6. You might want to adjust this gap in correspondence with the number of printed copies. Adjust the head position for
1. After you use one copy
2. After you use two copies
3. When you use three copies and so on....
A wrong correspondence involving head gap with all the number of printed copies will put on off the printhead pin wires and shorten it really is lifespan. In my printhead repair guide e-book, there's a chapter on ways to re-adjust the printhead gap manually on the its positioning and gap if they're misaligned.
4. Ribbon Mask.
Eliminate the printhead from the printer. Check when the ribbon mask is in great condition. If it really is not, modify the ribbon mask. A faulty ribbon mask occasionally may not only make the printing dirty but in addition will spoil the ribbon threads. A regular warranty for a printer is 1 year. This warranty does not normally incorporate the printhead. The explanation is, they do not know for those who use the original ribbon. Even if you might be getting a brand new printhead, no reseller will choose to give you a warranty.
Conclusion.
There are several dot matrix customers that are unaware of tips on how to take care of their printer specifically the printhead. I've repaired many printheads as a result of above mentioned reasons and a few of it are really new. It is actually not tough to repair it. What you'll need is just someone to guide and assistance you, and I am here to assist you.