This Week's Top Stories Concerning Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 is somewhat old-fashioned, but it is still striking. It might not be the plushest car in its class but an Ford Focus or Volkswagen Golf will help you stay away from surface imperfections - but it's a relaxing and pleasant drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will help whether the problem is intermittent, or constant.

Water Damage

If you happen to leave your fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting, or canyoning, it's most likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outside or perform activities that could expose it to a lot of water.

It's also crucial to ensure sure that the fob has dried before you open the fob and then use it. If you detect any smells emanating from the fob such as an industrial-type liquid smell or windshield washer fluid, it's another indication that it's submerged in water.

A circuit board that's damp can cause the battery to lose its energy or even explode. If you can pull your keyfob 308 from the water it is best to turn the button side up and shake as much water as you can prior to opening the casing. Once you have opened it, take out the battery and wipe down the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system that you use to enter your home may stop working include the battery of your coin is dead problems with the receiver module signal interference, a faulty electronic chip. If none of the above is the reason you can restart the system by disconnecting 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from a distance by warming up or cooling down the vehicle prior to getting in. This feature is extremely useful especially during the cold winter months. The remote start system can be stopped for a variety of reasons, such as a dead coin-battery.

A coin-shaped battery that is located inside the key fob can last for a period of between two and four years, depending on how often utilized and where it was purchased. The date of use is typically printed on the packaging or marked in the manual.

If the key fob stops working after exposure to water that is clean it is recommended to remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have fried the chip. It is recommended to replace it.

If you're not sure whether the battery is in good condition, you can check the voltage using a multimeter attached to both the terminals plus and minus. The voltage should read approximately 12-13 volts, however, if it reads lower, the battery must be replaced. You can also try to reset the onboard computer by disconnecting the 12 volt battery for a short period of time, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should now start.

Faulty Receiver Module

If you don't see the "Key Detected" It could be the receiver module malfunctioning. It's the part that transmits an indication to the car when your key fob is activated, it also acts as an immobiliser. It also stops it from starting unless the correct key is used.

This can be due to a number of factors, including water damage or just the aging process. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was contaminated with it. In this instance, you'll need to remove it and clean it thoroughly using isopropyl or an electronic cleaner. When the battery is dry you can attempt to test it again.

If the issue persists you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They can employ a diagnostic tool in order to pinpoint the issue and fix it.

It is stressful to lose your Peugeot car key. However, a professional auto locksmith can address the issue in just a few minutes. peugeot boxer key fob programming can cut a brand new key and programme it to your vehicle, so you're ready to get to the road as quickly as possible. Click here to find the nearest locksmith.

Electronic chip malfunctions

The electronic chip inside the Peugeot 308 key fob plays a vital function in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this case, the only solution is to replace the key. Professional auto locksmiths are able to provide this service within the shortest possible time.

The chip inside the key fob of your Peugeot 308 may become faulty for many reasons, such as sweat, water damage, or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned as soon as possible. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to dry completely.

Radio interference can cause the key fob to stop working. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this problem.

The Peugeot 207/308 Key Fob is delicate and requires special attention. It should not be dropped or throw it around. If you lose it, try to find it as quickly as is possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Disconnect the negative cable prior to the positive.