This Week's Most Popular Stories Concerning Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit but it's still eye-catching. It's not the plushest car in its class but it's a Ford Focus or Volkswagen Golf will isolate you even better from sloping surfaces - but it's a relaxing and pleasant drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is persistent or intermittent.

Water Damage

If you accidentally drop your key fob in the puddle, or it is soaked while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag when you're outdoors or performing activities in which the fob may be exposed to excessive amounts of water.

It is also important to make sure that the fob is dry before opening it up and using it again. If you notice any odors coming from the fob, like an industrial-like liquid smell or that of windshield washer fluid, this is another indication that it's been submerged in water.

A circuit board that's damp can cause the battery to discharge its charge or even explode. If you're able to fish the 308 key fob of the water in which it was stuck in turn the button upside down and shake out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board clean using a cotton swab which has been submerged in 90 percent alcohol.

Other reasons why your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issues signal interference, or a defective chip. If none of these is the cause, you can try resetting the system by removing the 12 volt battery for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start systems that allows drivers to start their car from the distance, allowing them to warm up or cool down the car prior to entering. This feature is extremely useful, especially in the cold winter months. Remote start systems can stop working for a variety reasons, such as the battery being dead.

The coin-shaped battery that is inside the key fob will last between two and four years depending on how frequently it is used, where it was purchased and how it is utilized. The use-by date will be written on the packaging or mentioned in the user's manual.

If the key fob stopped functioning after exposure to clean tap water and you want to take the battery off, clean the chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it could have fried the chip. You'll need to replace it.

If you're unsure if the battery is defective, you can test its voltage using a multimeter that is set to the car's voltage range, and connect it to the plus and minus terminals. If the voltage is less than 12-13 volts, then you need to replace the battery. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should be able to start after this.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the component that transmits the signal when your key fob is activated. It also functions as an alarm, and stops the car from starting if you don't have the correct key.

This could be due to a variety of causes, such as water damage or simply the aging process. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was exposed to it. In this scenario, you'll have to take it off and clean it thoroughly using isopropyl or electronic cleaner. When the battery is dry, you can try again.

If the issue isn't resolved the issue persists, it's a good option to consult an area Peugeot specialist or locksmith. They can use an instrument for diagnosing to pinpoint the problem and fix it.

The loss of your Peugeot keys to your car is an incredibly stressful experience. A certified auto locksmith will be able to solve the issue in a matter of minutes. They can program your vehicle and cut a new, functioning key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you may be unable to start your car or receive a message stating "anti-theft". In this case the only option is to replace the key. Luckily, professional auto locksmiths can complete the task in the shortest amount of time.

The chip inside your Peugeot 308's key fob may become faulty for various reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must clean it right away. You can wipe the electronic component with paper towels soaked with isopropyl Alcohol. Then, you need to let the battery completely dry.

Radio interference can cause a key fob to cease working. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects around the vehicle. If you experience this problem it is recommended to visit the Peugeot dealership.

The Peugeot 207/308 key fob is extremely delicate and requires a lot of care. peugeot 207 remote key programming is not recommended to drop it or throw it around. If you lose it, try to locate it as soon as you can. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Be sure to disconnect the negative cable first, then the positive.