This Is The Ultimate Cheat Sheet On Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 is somewhat old-fashioned however it's still appealing. It's not the plushest car in its class It's the Ford Focus or Volkswagen Golf will help you stay away from imperfections on the road - however, it's a comfortable and civilised driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. These tips can assist whether the issue is intermittent, or constant.
Water Damage
If you accidentally drop your key fob into a puddle or it is wet while kayaking, canoeing or rafting or canyoning the fob is more likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry container when you're outdoors or performing things where the fob might be exposed to high levels of water.
It's also crucial to ensure sure that the fob is completely dried out before you open it and use it again. If you detect any smells emanating from the fob such as an industrial-type liquid smell or that of windshield washer fluid, it's another indication that it's been submerged in water.
A circuit that is wet can cause the battery's power to be depleted or even explode. If you can get your keyfob 308 from the water you need to turn the button side up and shake as much water out as possible before opening the casing. When you've opened it, take out the battery and wipe the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery or receiver module malfunction, signal interference or a malfunctioning chip. If none of the above are the issue, try resetting the system by disconnection of the battery at 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start systems which allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the car prior to entering. This feature is extremely useful particularly during the cold winter months. However, there are times when the remote start system stops operating due to a range of causes, such as a dead coin battery.
A coin-shaped battery that is found inside the key fob has a lifespan of two to four years, depending on how often it's utilized and where it was purchased. The date of use is written on the packaging or in the user manual.
If the key fob has stopped working after exposure to water that is clean then you must remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. In the event of exposure to salty or soapy water, the chip may be damaged and you'll require replacing the key fob in total.
If you're unsure if the battery is faulty you can check its voltage with a multimeter set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts it is time to replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you don't see "Key Detected" you might find that your receiver module is faulty. It's the component that sends an alarm to the car when the key fob is activated it also acts as an immobiliser. It also stops it from starting until the correct key is in place.
This could be due to a number of reasons, including water damage or simply ageing. If your Peugeot 308 key fob has been exposed dirty tap water, for example the electronic chip located inside the device will be damaged. In this scenario you'll need to remove off the battery and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the problem persists the issue persists, it's a good idea to seek out an area Peugeot specialist or locksmith. They'll be able make use of a diagnostic device to help pinpoint the issue and fix it.
It is stressful to lose your Peugeot car key. A certified auto locksmith will be able to resolve the issue within minutes. They can program your vehicle and cut a new working key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message stating "anti-theft". In this scenario the only option is to replace the key. Luckily, auto locksmiths who are professionals can complete the task within the shortest period of time.
The chip inside your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other reasons. If your Peugeot 308 key fob is exposed to soapy water, clean it immediately. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. The battery should be allowed to dry completely.
Radio interference can cause the key fob to cease working. The KeyLab can be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by unsafe conditions or objects that are close to the vehicle. If you have this issue, it is best to visit a Peugeot dealership.
The Peugeot key fob 207/308 is extremely delicate and requires special care. It is essential not to throw or drop the key fob. If you lose something, try to find it as soon as you are able to. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Remove the negative cable before the positive.