This Is The Ugly Real Truth Of Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be a little old however it's still eye-catching. It might not be the plushest car in its class but the Ford Focus or Volkswagen Golf will protect you from sloping surfaces - but it's a relaxed and pleasant driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following tips will aid.

Water Damage

If you leave your fob in the midst of a puddle or splash it with water during kayaking, swimming, canoeing, rafting or canyoning, it's more likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to a lot of water.

It's also essential to make sure that the fob has dried out prior to opening it and use it again. If you notice any odors emanating from the fob like an industrial liquid smell or the scent of windshield washer fluid, this is another sign that it's been submerged in water.

A circuit board that's damp can cause the battery's charge to drop its energy or even explode. If you're able, if you can, pull your key fob 308 out of whatever body of water it got stuck in then flip the button side down and shake out as much water as possible before opening the case. Once you have opened it, remove the battery and clean the circuit board using a cotton swab dipped in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery, receiver module problems signal interference, or a damaged chip. If none of these causes the problem, you can try resetting the system by disconnecting the battery with 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to getting in. This feature is extremely useful especially during the cold winter months. Remote start systems may be stopped for a variety of reasons, such as a dead coin-battery.

A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often it is used and where it's purchased. Its use-by date is typically printed on the packaging or marked in the manual.

If the key fob stops working after exposure to clean tap water, you should remove the battery, clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If you expose it to salty or soapy water, the chip may be fried and you will require replacing the key fob entirely.

If you're not sure whether the battery is in good condition You can test its voltage with an instrument connected to the terminals for plus and minus. The voltage should read approximately 12-13 volts, however, if it reads lower, the battery needs to be replaced. If you want to, you can try to reset your on-board computer by disconnecting the 12 volt battery for a couple of minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should now begin.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible that the receiver module has created a fault. It's the part that sends a signal to the car when the key fob is activated which acts as an immobiliser, and stops it from starting until the correct key is present.

This could be caused by many reasons, such as water damage or just ageing. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water it could be because the keyfob was exposed it. In this instance, you'll have to take it off and thoroughly clean it using isopropyl or an electronic cleaner. When www.thekeylab.co.uk is clean then you can try again.

If the issue persists, it is a good idea to see an area Peugeot expert or locksmith. They'll be able to utilize a diagnostic tool to help pinpoint the issue and repair it for you.

It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can address the issue in only a few minutes. They can program your car and cut a fresh, working key for you. Click here to find a locksmith near you.

Electronic chip that is malfunctioning

The electronic chip in the Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may have problems starting your car or receive a message stating "anti-theft". In this scenario, the only solution is to replace the key. Luckily, auto locksmiths who are professionals can offer the service within the shortest period of time.

The chip in the key fob of your Peugeot 308 may fail due to various reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. Then, you need to let the battery completely dry.

Sometimes the key fob may not function due to radio interference. This is usually caused by other devices use the same frequency as your Peugeot keyfob. It can also be caused by weather conditions or objects that are in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.

The Peugeot 207/308 Key Fob is fragile and requires particular care. It is imperative not to throw or drop the key fob. If you lose it, try to find it as soon as you can. You can reset the onboard computer by disconnection of the battery for a couple of minutes. Make sure you disconnect the negative cable first, and then the positive.