The Tutorial to Change Hi-Low Beams Headlights to LEDs in Dodge Ram

First start by getting rid of the plastic cover, you can use a flathead screwdriver, but the fastener removal tool makes this procedure a lot easier. Once you've removed the plastic cover, you'll eliminate the grille. Get rid of the 4 bolt with a socket.

After gotten rid of all four bolts, pull the grille with a little bit of force. Next is the headlights, there are two bolts on the front.

For more detailed information about these change, please visit this excellent site: https://www.customsportsspecial.com/.
Eliminate the bolts with ten millimeter socket, when those are removed, get rid of the plastic clip that is located under the wheel. After eliminated the clip reach in and push the white tab up. This will release the headlight. You will hear a click when you push up.

Once released the tab, pulled the headlight out and eliminate the circuitry harness by pushing the tab in. It is the very same to the another headlight housing. Eliminate the front 2 bolts, get rid of the plastic clip under the wheel and push the tab up and launch the headlight.

Getting rid of the dust cover with an 8 millimeter socket, after eliminating the dust cover, eliminating the low beam. Twisting the bulb counterclockwise, then unclip the circuitry harness from the bulb, the low beam headlight bulbs in automobile are 9005 base.


After lining up the H11 LED bulbs, turn the bulb clockwise. When the bulb remains in place, link the circuitry harness to the LED bulb. Next remove the high beam by twisting counterclockwise. The high beam headlight bulbs are 9005 base.

Unclip the wiring harness from the bulb. Prior to installing the high beams, you'll wish to adjust the bracket so that the LED bulbs fit incorrectly. Lowering and twisting intelligence in the proper position. When the 9005 LED bulbs are located correctly, line up the LEDs and twist clockwise. When the LEDs are secured link their wiring harness to the LED bulbs. When the connection is safe, we put the rest of the wiring harness and driver inside the lamp, that can properly attach the dust cover. Repeat these steps with the other headlight.