Temp Sender Resistance
prosicelbou1978
👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇👇
👉CLICK HERE FOR WIN NEW IPHONE 14 - PROMOCODE: 6PWAJIM👈
👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆👆
With engine cold, drain coolant below the level of existing temperature sender (dis-pose of coolant properly)
The tech told me that their temp sender P/N TS6469 has a resistance of 80 ohms +/- 10 percent at 220 degrees (boiling point of water/coolant) Less resistance equals more heat and thus the strip bends more . I can measure the resistance changing with temperature on my multimeter The power comes from the ignition switch through the gauge down to the sender unit and because the sender is a temperature controlled resistance unit the voltage is very low and so the gauge reads cold .
Easy test is to get out your multimeter and check for continuity between the post and the body of the sending unit
C-ME MARINE SALES America's First Supermarket of Boating Values By definition a thermistor changes resistance with a change in temp . Heating the temp sending unit will answer your question about whether or not it will close the circuit If 90C doesn't put the needle in the middle, adjust the voltage with a suitable in-line resistor .
6 1473 40 527 50 366 60 239 65 206 70 165 75 145 80 132 85 102 90 89 95 77 100 66 For water: 3
It is near the last head bolt and next to the valve cover If your fuel and/or temperature gauge work intermittently, or if they register way out of whack, you might need to replace this part . 193-0318 ONAN Part number 193-0318 SENDER-WATER TEMP The SENDER is for the gauge and uses the single pin since the gauge works off resistance .
These temperature senders are available with a variety of thread options to adapt to different applications
Shop restoration car parts and accessories at Ecklers Measure the resistance from the sender to ground, then from the gauge to ground; it should be the same . Conversely, when the tank is full, the resistance decreases, resulting in close to the maximum signal voltage being sent to the fuel gauge, thus producing a “Full” reading This provides a signal to the PCM, indicating the temperature of the incoming air charge .
Features a slit for easy installation onto a bundle of wires or a pre-assembled harness assembly, increasing productivity
👉 Eligible Redetermined Unemployment
👉 Leslie Phillips Car Accident Maryland