Placebo.ac

Setup Guide

1. Before running the loader, make sure the following are configured: • Secure Boot:
2. OFF • CPU Virtualization (Intel VT-x / AMD-V):
3. ON • Hyper-V:
4. ON • Discord Overlay:

Must match the screenshot below.

How to Check

1. CPU Virtualization
2. Press Ctrl + Shift + Esc to open Task Manager.
3. Go to the Performance tab.
4. Click CPU.
5. Check Virtualization in the bottom-right.
6. Enabled = Good
7. Disabled = Enable it in your BIOS.
8. Secure Boot
9. Press Win + R, type
   , then press Enter.
10. Find Secure Boot State.
11. It should say Off.
12. Hyper-V • Run the provided Enable Hyper-V.bat file as Administrator. • Once it finishes, restart your PC. Discord Overlay • Make sure your Discord Overlay settings match the screenshot below before launching the loader.

Do NOT continue until all requirements above are configured correctly.

Installation

1. Run the Loader as Administrator.
2. Log in or create an account.
3. Click Inject to install the Hypervisor.
4. Once the installation is complete, restart your PC.
5. After rebooting, launch the Loader again as Administrator.
6. Click Inject one more time.

The software will load successfully and you're ready to play.

Important

1. • This product uses a Hypervisor-based bypass, so a restart is required after the first injection. • Whenever the Hypervisor needs to be loaded again, you must restart your PC before using the software. • If the software isn't working, verify that Secure Boot is OFF, Virtualization is ON, Hyper-V is enabled, and your Discord Overlay matches the screenshot below before opening a support ticket.