Peugeot 308 Key Fob 10 Things I Wish I'd Known Earlier
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a little, but it still feels appealing. It might not be the most luxurious car in its class but it's a Ford Focus or Volkswagen Golf will shield you from sloping surfaces - but it's still a pleasant and a civilized drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. If the issue is persistent or intermittent, the following tips should aid.
Water Damage
If you happen to leave your fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's likely to sustain water damage. The best method to prevent this from happening is to always keep it in a dry bag whenever you're out in the open or engaging in activities that require the fob to be exposed to excessive amounts of water.
It's also crucial to ensure sure that the fob is completely dried before you open the fob and then use it. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's submerged.
A circuit board that's damp can cause the battery to dump its charge or even explode. If you're able fish your key fob 308 out of whatever body of water it was stuck in then flip the button side down and shake out as much water as you can before opening the case. After you open it, take out the battery and wipe down the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery, receiver module problems signal interference or a damaged chip. If none of the above are the issue, you can reset the system by removing the 12 volt battery from your vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to entering. This feature is extremely useful especially during the cold winter months. However, there are times when the remote start system ceases operating due to a range of causes, such as an unresponsive coin battery.
The coin-shaped battery inside the key fob can last between two and four months, depending on how often it's used, where it was purchased, and how it is used. The date of use is usually printed on the package or listed in the instruction manual.
If the key fob stops working after exposure to water that is clean, you should remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to become damaged. You'll need to replace it.
If you're not certain the battery is in good condition You can test the voltage with an instrument set to the car's voltage range and connected to the plus and minus terminals. The voltage should read approximately 12-13 volts but if it's lower, then the battery needs to be replaced. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, then it's possible that your receiver module has developed a fault. please click the following web site 's the part that transmits an alert to the car when your key fob is activated that also acts as an immobiliser and prevents it from starting unless the correct key is present.
This could be due to a number of reasons, including water damage or simply the aging process. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was in contact with it. In this scenario, you'll need to remove it and thoroughly clean it with isopropyl or an electronic cleaner. When the battery is clean, you can try again.
If the issue persists, it's probably a good idea to seek out a local Peugeot specialist or locksmith. They'll be able employ a diagnostic tool help pinpoint the issue and repair it for you.
It is stressful to lose your Peugeot car key. However, a professional auto locksmith can solve the issue in a matter of minutes. They can cut a brand new key and programme it to your vehicle, so you're back out on the road in the shortest time possible. Click here to locate a locksmith in your area.
Electronic chip malfunctions
The chip inside your Peugeot 308 key fob is an important component of the remote control system. If the chip is damaged, you could have problems starting your car or receive a message that says "anti-theft". In this scenario the only option is to replace the key. Auto locksmiths with experience are able to provide this service within the shortest possible time.
The chip inside your Peugeot 308's key fob may fail due to a variety of reasons, such as water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, you must cleanse it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. The battery should be allowed to completely dry.
Sometimes, a key fob can not function due to radio interference. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It could be caused by problems with the environment or objects within the vicinity of the vehicle. If you experience this issue it is advised to visit an Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and requires special care. It is essential not to drop or throw the key fob. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Disconnect the negative cable prior to the positive.