Купить попперс Красноярск

>>> Сделать заказ <<<

>>> Сделать заказ <<<

We are ready to spin but go slow and steady Next we insert the Bolt into the Hole so that the can is held between the two washers and tightened by the two nuts My bolt was 8mm in diameter so I used the 8mm drill bit Now cut the other end a bit shorter and tuck it under the rest of the wool on the can with a nail I love upcycling things that would otherwise get thrown away so I started making these flower pots from the tin cans that the local pizzeria uses Thread this end into the loop that we prepared earlier and slowly start tugging on the other end photo 8 away from the can so that the loop takes the loose end with it and hides it underneath the wool completely I found it useful to put the main wool ball into another can directly underneath this way it can uncurl itself better and steadier From time to time stop the screwdriver and move the wool closer together to avoid visible can metal underneath The drilled hole might still have some sharp metal so carefully file it or make it flat with a hammer Slowly start your screwdriver to spin the can while holding the rope in your hand and guiding it into neat loops around the can I used the center finder ruler intersection of diameters gives you a precise center but our hole doesn t have to be very precise so you can even eyeball it The first step is to find the approximate center of the pot floor punch a hole and drill it out with the drill bit of the same size as your bolt This hole will not only be useful to spin the can with your power tool but also to drain excess water later when in use as a flower pot We will use this loop to hide the end of the thread when we are finished You can use one nut but I had it unscrew on me in the process so I купить попперс Красноярск using the second nut to prevent it When you have fully covered the can cut the end of the thread leaving about 5cm 7in Now we lay a loop of your thread onto the side of the can leave a little loop hanging on top and secure it with tape Next fix the bolt in your screwdriver You can use these pots as outer decorative pots or even fill them with soil in which case I d recommend punching some more small drainage holes in the bottom