It's The Complete Cheat Sheet On Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit, but it still feels attractive. It might not be the plushest car in its class and a Ford Focus or Volkswagen Golf will shield you from imperfections on the road - however, it's a comfortable and civilised driving experience.
We get asked frequently at Coded Car Keys to replace peugeot key fobs. The following tips will help whether the problem is constant or intermittent.
Water Damage
If you accidentally drop your key fob into a puddle or it gets wet while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry container when you're outside or performing activities that require the fob to be exposed to high levels of water.
You should also make sure that the fob is completely dry before opening it up and reusing it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid), this is another sign that it has been submerged.
A circuit board that's damp can cause the battery to discharge its charge or even explode. If you can pull the 308 keyfob from the water and turn it upside up and shake as much water as you can before opening the casing. After opening it, take out the battery and wipe down the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery, receiver module problems, signal interference or a malfunctioning chip. If none of these are the cause, you can try resetting the system by disconnection of the battery at 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start technology which allows drivers to start their car from some distance, which allows them to warm up or cool down the vehicle prior to entering. This feature is very useful, especially in the cold winter months. Remote start systems can be stopped for a variety of reasons, such as an inactive coin-battery.
A coin-shaped battery that is located inside the key fob has a life span of between two and four years, depending on how frequently it is used and where it's purchased. The date for use-by is typically printed on the package or written in the manual.
If the key fob stops working after exposure to clean tap water, you should remove the battery, clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If exposed to soapy or salty water, the chip may be fried and you will have to replace the key fob completely.
If you're not sure the battery is faulty it is possible to test its voltage using a multimeter that is set to the car's voltage range. Connect it to the plus and minus terminals. If the voltage is less than 12-13 volts, then it is time to replace the battery. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.
Faulty Receiver Module
If you aren't seeing the "Key Detected", it could be the receiver module faulty. peugeot 107 replacement key 's the component that sends an indication to the car when your key fob is activated, that also acts as an immobiliser. It also stops it from starting until the correct key is present.
The cause could be several reasons, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, like, the electronic chip inside is damaged. In this situation, you'll have to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try again.
If the issue persists the issue persists, it's a good option to consult an area Peugeot specialist or locksmith. They can employ a diagnostic tool in order to pinpoint the issue and repair it.
Losing your Peugeot car keys can be an incredibly stressful experience. However, a trained auto locksmith can address the problem in minutes. They can cut a brand new key and then program it into your vehicle, ensuring you're ready to get out on the road in the shortest time possible. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is an crucial component of the remote control system. If it is damaged, your car may not start or you may receive a message that reads "anti-theft active". If this occurs, the only way to fix the problem is to get a new key. Fortunately, professional auto locksmiths are able to provide this service in the shortest amount of time.
The chip inside your Peugeot 308's key fob could fail due to different reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must take it to the cleaners immediately. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. Then, you need to let the battery completely dry.
Sometimes keys can cease to function due to radio interference. This can be caused when other devices use the same frequency as your Peugeot keyfob. This could be due to unsafe conditions or objects that are within the vicinity of the vehicle. If you encounter this issue it is advised to visit an Peugeot dealership.
The Peugeot key fob 207/308 is very delicate and requires special attention. You shouldn't drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset the on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative cable first, then the positive.