How To Use Graphics - Tricking Out Your Dirt Bike

Never before have there been as many choices available to personalize the appearance of your dirt bike, ATV, UTV or motorcycle, and that includes decals and graphics in every color and design you can think of. It's enjoyable to pick the graphics that you are drawn to, but it may be difficult to apply them in case you aren't sure how.

How to Install Dirt Bike Graphics

These are the steps to apply graphics in a simple way that will ensure that your graphics stay in place.

Dry Installation

1. Clean your plastics, hands and the area you work in. Clean away dirt and oil, as well as old adhesive and anything else from the front and back side of your machine's plastic. You may get more info about dirt bike by visiting https://www.flippingheck.com/how-to-choose-a-graphics-company-for-your-dirt-bike/ site.

2. Trim the paper backing as close to graphics before applying them to your dirtbike. Take the backing off of the paper from the vent's interior and bolt holes. Verify the alignment of holes, vents and curves as well as edges of the graphic against the plastic.

3. Remove half of the backing, taking care not to let dust or debris to collect on the adhesive side. For side plates cut the backing vertically and horizontally for the front plates. Take a half inch strip of backing and cut it off. Attach the backing that remains to graphic, aligning it with holes and edges.

4. Keep the center strip from sticking as you align the graphic to the plastic. After it's aligned properly then apply the center strip of the graphic to the plastic.

5. Peel back the paper backing from one side, and then hold the image up and away from the plastic. Apply the graphic slowly by sliding your finger back and forth along the graphic, pressing out any air bubbles and wrinkles. To eliminate wrinkles and air bubbles, heat is a good option using the help of a hair dryer, or a heat gun during this process. Attention: Overheated heat could cause the decal to stretch too much and cause distortion to the image.

6. Remove the backing paper of the other side , and apply the image as that is described in step 4. For all other graphics, follow the same steps.

Wet Installation

1. Clean your hands, plastics and the area you work in. Remove dirt or oil, old adhesive and anything else from the back and front sides of the plastic on your machine.

2. Before applying, trim the paper backing around the perimeter as close to the graphic as is possible (without actually cutting off the graphic). Remove the paper backing from the inside of the vent and bolt holes. Verify the alignment of holes, vents, curves , and edges of the graphic in relation to the plastic.

3. Spray a fine mist of application fluid on your plastic.

4. Take the backing paper off your decal. Make sure to keep the adhesive side clear of dust, dirt and debris. Apply a fine mist fluid to spray the adhesive side.

5. Apply the decal lightly onto the plastic, while filling up vent holes.

6. After everything is in place Start from the middle and move the liquid to the edges using the help of a squeezer.

7. To speed up drying, heat may be added to the squeegee by using either a hair dryer. Heat can also be used to smoothen wrinkles and remove any bubbles. Warning: Heat can cause decals to stretch and distort if they are exposed to excessive heat.

8. To clean any remaining fluid on the edges of the plastic clean, dry clean cloth.

9. It is suggested that you do not ride your quad or dirt motorbike for at least 24 hours to ensure that the decal is properly adhered to your decal.