How To Apply Graphics: Rricking Your Dirt Bike

There are a myriad of ways to customize your dirt bike, UTV, UTV, or motorcycle's look - graphics and decals come in every shade and style. It's fun to choose the designs you are drawn to, but it may be a challenge to put them on if you don’t know how to apply them.

How to Install Dirtbike Graphics

Attack Graphics is an expert graphics shop, specializing in motorsports. The graphic artists at Attack Graphics are experts in applying graphics to offroad vehicles. These are the steps for applying graphics in a manner that is simple and can ensure that your graphics remain in place and stick.

Dry Installation

1. Clean your hands, your plastics, and the work area. Clean away dirt and oil, as well as old adhesive and any other material from the front and back sides of the plastic on your machine. Once you want to discover further more information about dirtbike graphics, you've to check here at https://www.apzomedia.com/best-womens-dirtbike-riding-gear-fall-riding/ site.

2. Before applying to the back of the sheet, trim it around the perimeter to be as close to the graphic as possible (without actually cutting the graphic). The backing of the paper must be taken away from vents and bolt holes. Check that the lines of your holes, vents and curves as well as the edges of your graphic with the plastic.

3. Remove half of the backing, taking care not to let dust or debris to collect on the adhesive side. Cut the backing along the center horizontally for side plates and vertically for front plates. Cut a half-inch strip of the first half of the backing. The remaining backing can be put on top of the graphic. Line it up with gaps or edges.

4. Make sure that the center strip isn't sticking as you align the graphic with the plastic. Once the graphic is aligned, attach the strip that is the center to the plastic.

5. The backing of the paper must be removed from one side. Secure the image in the correct position and keep it from the plastic. Slowly apply by sliding one finger back and forth along the image, pressing out any air bubbles and wrinkles. The heat can be applied using a hair dryer or a heat gun in this procedure to get rid of wrinkles and air bubbles.

6. Remove the backing paper from the opposite half Then, apply the design as explained in step 4. For all other graphics, repeat the steps.

Wet Installation

1. Be sure to wash your hands, your plastics, and the area you work in. Clean your plastic on the side and back.

2. Before applying to the back of the sheet, trim it around the perimeter to be as closely as is possible (without actually cutting the graphic). The paper backing should be removed from the inside of the vent and bolt holes. Examine the alignment of the holes, vents, curves, and edges of your graphic against the plastic.

3. Use a fine mist on your plastic.

4. Take out the backing paper and make sure the adhesive side is clean. Spray the adhesive surface with a fine mist application fluid.

5. Place the decal on the plastic, while marking vent holes.

6. After everything is put in place Start from the middle and move the liquid to the edges with a squeezer.

7. While you are continuing the squeegee procedure and continue to squeegee, you can add heat with a heat gun or hair dryer in order to speed up the drying process. It can also be used to smoothen wrinkles and remove any bubbles.

8. To wipe any fluid left around the edges of plastic clean, dry clean cloth.

9. To ensure adhesion, it's best to not ride your dirtbike or quad for more than 24 hours.