How Do You Install Dirt Bike Graphics

Substance Incorporated is our long-term partner in dirt bike graphics. Substance Incorporated, a market leader in the production of motocross graphics for screen printing and digital printing is a company with unmatched enthusiasm and creativity. Check out https://www.facebook.com/decallaboratory/ site for fruitful information about dirtbike graphics now.

Just before you begin

Take a look at your plastics and see If they're scuffed, damaged, or scratched it is worth looking at replacement of the parts. The dirt bike's plastics have to be in great order before installing dirt bike graphics kits.

The following items are required to put dirt bike graphics on your vehicle:

adhesive tape for paper;

paper knife / scissors;

hair dryer or heat gun

Alcohol-water, also known as a degreasing agent or alcohol.

squeegee (optional);

Wash your hands thoroughly. When working on surfaces or preparing them with graphics , it is essential to clean your hands. Hands that are oily or dirty can affect dirt bike graphics' ability to adhere.

Preparing surface

It is crucial to get rid of any old labels before you are able to put on dirt bike graphics. To make old graphics easier to remove, make use of a hair dryer or heat gun. Degreasing agents can be used to clean the surface. It is crucial to eliminate any residues of glue, oil or dirt from old graphics. The plastics on the dirt bike need to be warmed up prior applying the motocross graphics. We suggest that you keep your plastics in a room that has a temperatures of more than 15 degrees Celsius or 60oF for a couple of hours.

Applying graphics

Put your logo onto the plastic. Number plate Apply the decal on the plastic using adhesive tape. The tape will help hold the decal in the right place. You can choose the amount of tape you want to use. Take the backing paper off the background, then cut it. Make sure you are aligned with the area that you intend to cover. Touch one side of the graphic using your fingers to position it in the position you want it to be.

You can work in sections using the using your fingers or squeezers to apply pressure to the images. Be careful not to create wrinkles or bubbles. Begin by working towards the middle. You can remove any bubbles by gently peeling the area off and then trying again. To pop tiny air bubbles, use the safety pin. Then, smooth the bubble section by moving toward the edges. It is possible to repeat this process on the other part of the decal.

If you notice sharp lines in your plastic Use a an electric heat gun to melt the graphics to soften them. Be careful not to overheat!

If needed cut off excessive sections or graphic that cover bolts, vent holes, or access slits. Utilize a knife made of paper.

Set up guidelines

Be patient and patient! It's not as hard as you may imagine.

For several hours before installation make sure that you keep your plastics and dirt bikes in their place at temperatures greater than 15degC/60oF for an extended period of time.

Be sure that bonding is done correctly prior to your ride.