Ford Fusion (2024) Manual
Can’t find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Ford Fusion (2012) below. How do I convert miles into kilometres? Where can I find the VIN number of my Ford? The location of the VIN number of the car differs per brand and type of car. The code may be stamped on the frame of the car or mounted on a plate. It is best to consult the manual of the Ford Fusion (2012)for the exact location of the VIN number. What is a VIN number? The VIN number of a car is an identification number unique to each car. The abbreviation VIN therefore stands for Vehicle Identification Number. When does my Ford need maintenance? Regular maintenance is necessary for every car. How often the car needs maintenance and what exactly needs to be done can be found in the maintenance instructions. For major periodic service, this should generally be done every 2 years or after 30,000 kilometres.
When should I change the brake fluid of my Ford? It is recommended to change the brake fluid every two years. What is the difference between E10 and E5 petrol? E10 petrol consists of up to ten per cent ethanol while E5 petrol will contain less than five per cent ethanol. As a result, the percentage of E10 petrol is lower than that of E5 petrol, making it less bad for the environment. One or more doors won’t open from the inside. The lock is most likely set to the child safety lock so it cannot be opened from the inside. How to unset the child safety lock differs per brand and type. My car radio does not turn on, now what? If your car radio does not turn on, it will not receive any power. Check that the red wire is connected to the contact power supply and the yellow wire to the constant power supply.
To adjust the seat position, locate the lever on the side of the seat and lift it up to move the seat forward or backward. Use the knob at the front of the seat to adjust the seatback angle as per your comfort. To reset the tire pressure monitoring system, start by ensuring all tires are properly inflated based on the recommended tire pressure levels found on the driver’s side door jamb. Then, press and hold the TPMS reset button, typically located inside the glove box, until the TPMS indicator light blinks three times. To change a flat tire, locate the jack and spare tire in the trunk. Place the jack in the designated area, usually indicated by small notches near the flat tire. Use the lug wrench to loosen the lug nuts, then raise the vehicle by turning the jack handle clockwise. Once lifted, remove the lug nuts, replace the flat tire with the spare tire, and tighten the lug nuts in a star pattern.
Finally, lower the vehicle back down using the jack and ensure all lug nuts are securely tightened. To check the engine oil level, park the car on a level surface and ensure the engine is turned off. Locate the dipstick, usually labeled «Engine Oil» and usually yellow or orange in color. Pull out the dipstick, wipe it clean with a cloth, and reinsert it fully. Pull it out again and observe the oil level between the «min» and «max» indicators on the dipstick. If the level is towards or below «min,» add the recommended engine oil as needed. To jump-start your car, you will need a set of jumper cables and a second vehicle with a functioning battery. Park both vehicles close together but ensure they do not touch. Connect one end of the positive (red) cable to the positive terminal of the dead battery, then connect the other end of the positive cable to the positive terminal of the working battery. Next, connect one end of the negative (black) cable to the negative terminal of the working battery and the other end to an unpainted metal part of your car’s engine block. Start the engine of the vehicle with the working battery, then attempt to start your Ford Fusion. Once your car starts, let it run for a few minutes before disconnecting the cables in reverse order.
Подробнее читайте на: volna casino скачать на андроид