7 Simple Tips For Rocking Your Nissan Qashqai Key Fob
Reasons Why Your Nissan Qashqai Key Fob Won't Work
The Qashqai has a distinctly SUV-like feel due to its bigger dimensions, and the 19-inch wheels on Ti and ST-L models can be a bit spongy at times. The front tyres in the Qashqai may also lose grip on rough surfaces, and the CVT could occasionally display wrist-flexing torque steering.
This is typically caused by an unresponsive battery that can be replaced in just a few minutes. Make sure that the replacement battery is of the same size, voltage and specifications.
Water Damage
Water damage is one of the most frequent causes for the Nissan keyfob to display the "key ID incorrect" message. The key fob comes with rubber seals that shield the electronic chip inside. However, prolonged exposure to moisture could cause it to cease functioning properly. It's common to see this happen if your key fob has been dropped into the water or a swimming pool. It can also happen when it gets wet due to rain or soapy hand.
If your key fob has been exposed to water for the course of a long time, you may need to clean it with isopropyl, or an electronic cleaner. It may also require a visit to a specialist to repair or replace it.
If your key fob require replacement the process is simple. Make sure you have the proper multipack (CR2032 3V). Open the front and rear cases using the flat-head screwdriver. You'll have to remove the metal retaining clips and then push out the old battery, and then insert the new one. After reassembling the fob, put the mechanical key back into its place and make sure it operates correctly. If it isn't then you'll need to take it to an Nissan dealer or professional auto locksmith to repair the key chip. Fortunately the chip isn't usually damaged by water exposure which means that this shouldn't cost you a lot.
Dead Coin Battery
The coin battery is a second common reason why your Nissan Qashqai remote key fob might not function. These batteries last for three to five years, however they are prone to failure over time when the fob is dropped frequently. You can replace the battery with a fresh one, but make sure that it's the same size and voltage as the original. If you replace the battery, it may cause the key to be assigned an incorrect key ID. This can prevent it from being linked to your vehicle.
The most efficient method of replacing the battery in a Nissan Qashqai key fob is by prying open the key fob using a small flat head screwdriver. The screwdriver should be inserted into a small notch on the bottom of the fob, and turn it around gently to separate the two halves of the key fob. Remove the old CR2025 battery and replace it with a new one, making note of the position of the previous one inside the fob.
Check the terminals for dirt or water damage prior to installing the new battery. If not clean the terminals with some isopropyl ethanol. Make sure that the pole cables are connected correctly. They should be connected to both the negative and the positive poles of your battery.
Fault Diagnosis
If your Nissan Qashqai's key fob stops functioning after being exposed to pure rainwater or clean tap water it could be a sign that there's a problem with the internal chip. Change the battery won't fix this, and you'll have to buy another key fob. If the key fob stopped working after dropping it, it is likely that the chip inside was damaged. If nissan qashqai replacement key clean the chip with isopropyl ethanol and paper towel and then replace it with the key fob, you can typically get it working again.
Key ID Incorrect is a typical error you may see on the dashboard of your car. The vehicle is not able to recognize the key fob and consequently, won't allow the vehicle to start. The problem can be caused by a variety of factors including water damage, undetectable problems in the key fob's circuitry or RFID interference.
If the 12 volt battery in your key fob is broken or is not supplying sufficient electric current it will cease to function. This can affect your Nissan Qashqai's keyless system central locking, as well as the ability to start the engine with the key fob. Examine the batteries on the key fob if it is not able to lock and unlock your door manually. You may also try reconnecting the battery in order to reset your transmitter.
Reprogramming
If the key fob was not submerged in saltwater, it should be able come back to life with a simple rinse of clean water. You can also clean the electronic chip using isopropyl or electronic cleaner. If these don't work, it may be time to replace the entire key fob by a new one.
If your Nissan Intelligent Key is still not working, it could be an issue with the connection between it and your car. Start by turning the ignition key but not activating the vehicle. Repeat this process until the hazard light flashes two times. Turn the vehicle off and take out the keys.
Next, then open the fob compartment in your vehicle. This is usually located in a door jamb, on the handle on the driver's side or under an armrest. Find the small "program" button and press it. Once the process has been completed you will hear a chime.
It's time to test your Intelligent Key to the test. Make sure you press all the buttons on the key while you are at a distance from the vehicle. If the lights flash and the horn sound this means that the key has successfully connected to the Nissan. It is also possible to test the key in close proximity.