7 Simple Changes That Will Make A Big Difference In Your Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 is somewhat old-fashioned but it's appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable drive.
We often receive requests from Coded Car Keys to replace peugeot key fobs. Whether the problem is constant or intermittent these tips will assist.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking canoeing, rafting, or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry, dry bag when you're outdoors or performing activities that require the fob to be exposed to excessive amounts of water.
You'll also want to ensure that the fob is completely dry before opening it up and using it again. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) This is a further sign that it has been submerged.
A circuit board that's damp can cause the battery to discharge its charge, or even explode. If you can pull the 308 keyfob from the water you need to turn the button side up and shake as much water as you can before opening the casing. Take the battery out, and then clean the circuit board with a cotton swab, which has been dipped in 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issue signal interference, or a faulty chip. If none of the above is the issue you can reset the system by removing the 12 volt battery from your car for 15 minutes.
peugeot 108 key cover come with a remote-start system which allows the driver to start the car from afar while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely helpful particularly during the winter's cold and chilly months. However, sometimes the remote start system ceases working due to a variety of reasons, including an unresponsive coin battery.
A coin-shaped battery found inside the key fob has a life span of between two and four years, based on how often used and the location where it was purchased. The date of use is typically found on the packaging or listed in the instruction manual.
If the key fob stops working after exposure to water that is clean and you want to remove the battery, then clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to become damaged. You will need to replace it.
If you're unsure whether the battery is damaged it is possible to check its voltage with a multimeter connected to both the terminals plus and minus. If the voltage is lower than 12-13 volts then you should replace the battery. You can also attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you don't get the "Key Detected" you might find that your receiver module is defective. It's the component that sends an alarm to the car when your key fob is activated, that also acts as an immobiliser and prevents it from starting until the key that you want to use is present.
This could result from a variety of causes including water damage or simply the aging process. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water it could be due to the fact that the keyfob was exposed it. In this instance, you'll need to remove it and thoroughly clean it using isopropyl or electronic cleaner. When the battery is dry you can try it again.
If the issue persists, it is recommended to visit an area Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the problem and fix it.
It is stressful to lose your Peugeot car key. However, a qualified auto locksmith can resolve the issue in only a few minutes. They can program your vehicle and cut a new, functioning key for you. Click here to find a locksmith near you.
A malfunctioning electronic chip
The electronic chip in the Peugeot 308 key fob is a critical part in the remote control system. If it is damaged your car might not start, or you could receive a message that reads "anti-theft active". If this occurs, the only option to fix the issue is to replace the key. Fortunately, auto locksmiths with experience can offer the service within the shortest period of time.
The chip inside the key fob of your Peugeot 308 could be damaged due to various reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob has been exposed to soapy water, you should clean it right away. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should then be allowed to fully dry.
Sometimes, a key fob can stop working because of radio interference. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects in the vicinity of the vehicle. If you have this issue you should visit the Peugeot dealership.
The Peugeot key fob 207/308 is very delicate and requires care. You shouldn't drop it or throw it around. If you lose it, try to locate it as quickly as possible. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Make sure you disconnect the negative first, and then the positive.