4 Dirty Little Secrets About The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a little but it's still attractive. It might not be the most luxurious car in its class It's a Ford Focus or Volkswagen Golf will protect you from surface imperfections - but it's a relaxing and civilised driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can assist whether the issue is intermittent, or constant.
Water Damage
When you accidentally leave your fob in the midst of a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it's probably to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in activities that expose it to a lot of water.
It's also essential to make sure the fob has completely dried out before you open the fob and then use it. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid), this is another indication that it's been submerged.
A wet circuit could cause the battery's power to be depleted or even explode. If you are able to get your keyfob 308 out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. After you open it, remove the battery, and then clean the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might be unable to function could be due to a dead coin battery or receiver module issues signal interference, an electronic chip that is damaged. If none of the above is the issue you can restart the system by disconnecting 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars come with remote start systems that allows drivers to start their car from the distance, allowing them to warm up or cool down the car before they get in. This feature is very useful particularly during the cold winter months. However, there are times when the remote stop system stops operating due to a range of causes, such as the battery of a coin that is dead.
The coin-shaped battery located inside the key fob could last between two and four months, depending on how frequently it is used, the location it was purchased and how it is utilized. The date for use-by is typically found on the packaging or listed in the instruction manual.
If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to become damaged. You'll need to replace it.
If you are not sure the battery is defective it is possible to test its voltage with a multimeter set to the vehicle's voltage range and connected to the terminals for minus and plus. If the voltage is less than 12-13 volts you should replace the battery. Alternately, you could try to reset the onboard computer by disconnecting the battery at 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should now begin.
Faulty Receiver Module
If you don't get the "Key Detected", it could be the receiver module malfunctioning. It's the component which sends out an alert when the key fob activates. It also functions as an alarm, and stops the car from starting if it doesn't have the correct key.
This can be due to various causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed dirty tap water, like the electronic chip inside is damaged. In this case you will have to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once the battery is dry you can try it again.
If the problem persists the issue persists, it's a good idea to see an area Peugeot specialist or locksmith. They'll be able to employ a diagnostic tool assist in identifying the problem and repair it for you.
It can be stressful to lose your Peugeot car key. A certified auto locksmith can solve the problem within minutes. They can program your car and cut a new working key for you. Find the nearest locksmith.
Faulty Electronic Chip
The electronic chip that is in your Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". If this happens, the only way to fix the issue is to replace the key. Professional auto locksmiths can provide this service within the shortest possible time.
The chip in the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot key fob has been exposed to dirty or soapy water, it must be cleaned promptly. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery must then be allowed to dry completely.
Sometimes keys may not function due to radio interference. peugeot 207 car key g28carkeys.co.uk can be caused when other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by bad weather or objects in the vicinity. It is recommended that you visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is fragile and requires particular care. It is not recommended to drop it or throw it around. If you lose it, try to find it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Make sure you disconnect the negative first, and then the positive.