25 Amazing Facts About Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be slightly old however it's still eye-catching. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is intermittent or constant, the following tips should help.
Water Damage
If you happen to leave your fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's most likely to be damaged by water. Keep your key fob in a dry bag whenever you are outdoors or engage in activities that could expose it to a lot of water.
It's also essential to make sure that the fob is completely dried before you open it and use it again. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's been submerged.
A wet circuit can cause the battery's charge to be drained or even explode. If you are able to get your keyfob 308 out of the water, turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then wipe the circuit board clean using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons why your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issue signal interference, or a faulty chip. If none of these is the reason, you may try resetting your system by disconnecting the 12 volt battery for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that lets drivers start their vehicle from the distance, allowing them to warm up or cool down the car prior to entering. This feature is extremely helpful, especially during cold winter months. Remote start systems may be stopped for a variety of reasons, such as an inactive coin-battery.
A coin-shaped battery in the key fob has a life span of two to four years, depending on how often utilized and where it was purchased. The date of use is printed on the package or in the user's manual.
If the key fob is not functioning after exposure to water that is clean and you want to remove the battery, clean the electronic chip with a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. In case of exposure to soapy or salty water, the chip could be damaged and you'll have to replace the key fob completely.
If you're not sure whether the battery is damaged, you can check the voltage using a multimeter that is connected to both the terminals for plus and minus. If the voltage is lower than 12-13 volts it is time to replace the battery. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.
Faulty Receiver Module
If you don't see the "Key Detected" you might find the receiver module not working properly. It's that part that sends an alert to the car when your key fob is activated which acts as an immobiliser and prevents it from starting until the key that you want to use is present.
This could be due to a range of causes, such as water damage or simply ageing. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water, it could be because the keyfob was contaminated with it. In this situation you'll have to take the unit apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the issue continues to persist, it is a good idea to visit the local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the problem and fix it.
It is stressful to lose your Peugeot car key. A certified auto locksmith can resolve the issue within minutes. They can cut a new key and program it to your vehicle, ensuring you're ready to get on the road again as quickly as possible. Click here to find a locksmith near you.
A malfunctioning electronic chip
The electronic chip that is in the Peugeot 308 key fob plays a vital part in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or get a message saying "anti-theft". In this instance the only option is to replace the key. Fortunately, professional auto locksmiths can provide the service within the shortest period of time.
The chip inside the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, clean it immediately. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. After that, you should let the battery dry completely.
Sometimes peugeot key programming may not function due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. It could be caused by poor conditions or objects in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this issue.
The Peugeot 207/308 key fob is very delicate and requires special attention. You should not drop it or throw it around. If you lose something, try to find it as soon as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a few minutes. Unplug the negative cable prior to the positive.