15 Of The Most Popular Peugeot 308 Key Fob Bloggers You Must Follow
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a bit, but it still feels appealing. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. The following tips will aid whether the issue is constant or intermittent.
Water Damage
If you accidentally drop your key fob in an eddy, or it gets wet while kayaking canoeing or rafting or canyoning the fob is most likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry container when you're out in the open or engaging in things where the fob might be exposed to high levels of water.
It's also important to make sure that the fob is completely dried before you open the fob and then use it. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it's been submerged.
A circuit board that's damp can cause the battery to lose its energy or even explode. If you're able, if you can, pull your key fob 308 out of the water body it got stuck in then flip the button side down and shake out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board down with a cotton swab that has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system may be unable to function could be due to the battery of your coin is dead or receiver module issues signal interference, an electronic chip that is defective. If none of the above are the reason, you can reset the system by removing the 12 volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar and then warm up or cool down the vehicle prior to getting in. This feature is extremely beneficial particularly in cold winter months. However, there are times when the remote stop system stops functioning due to a variety of causes, such as a dead coin battery.
The coin-shaped battery inside the key fob will last between two and four months, depending on how frequently it is utilized, the place it was purchased, and the way it is used. The date of use is typically printed on the package or marked in the manual.
If the key fob stopped working after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. It is recommended to replace it.
If you're unsure whether the battery is defective you can check its voltage using a multimeter connected to both the terminals for plus and minus. If the voltage is less than 12-13 volts, then you need to replace the battery. If you want to, you can try to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has been afflicted with a fault. It is the part that sends out the signal when your key fob activates. It also functions as an alarm, and stops the car from starting if it doesn't have the correct key.
This could be due to a number of causes, such as water damage or simply aging. If the electronic chip within your Peugeot 308 keyfob has been damaged due to dirty tap water it could be because the keyfob was in contact with it. In this scenario you'll need to remove the device apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. When the battery is dry you can try it again.
If the issue continues to persist, it's probably a good idea to visit a local Peugeot specialist or locksmith. They'll be able to use a diagnostic tool to help pinpoint the issue and repair it for you.
The loss of your Peugeot keys to your car is an extremely stressful experience. However, a reputable auto locksmith can resolve the problem in minutes. They can program your car and cut a new, working key for you. Find locksmiths near you.
Electronic chip malfunctions
The chip in the Peugeot 308 key fob is a critical function in the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". In this case the only option is to replace the key. Fortunately, auto locksmiths with experience are able to provide this service within the shortest period of time.
The chip in the key fob of your Peugeot 308 could fail due to various reasons, including water damage, sweat or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned as soon as possible. You can employ a paper towel as well as isopropyl alcohol for cleaning the electronic component. The battery must then be allowed to completely dry.
peugeot car key cover can cause a key fob to stop working. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this issue, it is best to visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is fragile and requires special care. It is important not to drop or throw the key fob. If you lose it, try to locate it as quickly as you can. You can reset the on-board computer by disconnecting the battery for a few minutes. Remove the negative cable before the positive.