15 Gifts For The Peugeot 208 Key Replacement Lover In Your Life
Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob has stopped working after a few days, it could be due to a dead coin battery, water damage the receiver module or a damaged electronic chip. Fortunately, these issues are easy to fix and you'll be able to get your vehicle back to normal in no time!
The key blade could become worn out and lead to an unusable car key. This is a simple fix by visiting your local Car Key Man Auto Locksmith and let them put in a new key blade for you.
Battery
The key fob of your Peugeot 308 may die or become weak enough to not transmit a strong signal. The key fob might cease to function and stop you from locking or unlocking your doors, or even starting the engine. To fix this, you'll have to replace the battery inside the key fob.
You'll need to buy batteries for replacement from an auto parts store or at your local hardware store. When you buy the battery, ensure that it's new and hasn't been on the shelf for too long. A fresh new battery will have greater capacity and can transmit a stronger signal to the car.
After replacing the battery try unlocking the doors and locking them with the key fob. If the doors don't open it's likely that the receiver module inside the car is at fault. The local Peugeot dealer can reprogramme the receiver module.
The internal chip of the key fob could also be damaged. This can happen if you drop your key fob on the ground or expose it to water. The rubber seals that protect the chip from moisture might be worn down over time, especially if your key fob is exposed to water for extended durations, like submerging it in the ocean at the beach. To prevent this from happening it is recommended to keep your key fob away of water and out of water.
Water Damage
If your key fob becomes wet and soaked, whether you tossed it into the pool or fumbled it into the puddle, don't believe that it's an accident. While the key fob comes with rubber seals that protect it from water, prolonged exposure to water could cause damage to its electronic chip. Since water is such a good conductor so any water that is able to get inside the key fob could cause a chain of short circuits which will eventually destroy the chip. After removing the battery, scrub the contacts with isopropyl alcohol and dry it completely before putting it back into.
A dead battery might be the reason your Peugeot 308 won't start. If you have an extra vehicle, jumper cables can be used to get the engine working again. If the battery is the problem and it is not working, it should be replaced.
Another possibility is a defective receiver inside the vehicle, which could block the signal from the key fob. It could be a issue with the antenna, or wiring, or the key fob could be damaged. If you have an entirely new key fob, it could need to be programmed into the vehicle. If you're not able to solve the issue, contact an expert technician. A trained technician will be able to diagnose the problem quickly and fix it immediately.
Radio Interference
Interference can cause symptoms such as a key fob that isn't recognized or has a restricted range. The interference could be radiated or transmitted, which is caused by power and speaker cables that are too close to electrical components. In general, rerouting cables and moving them away from these components can solve the issue.
It's unlikely that someone is listening to your key fob signal in an attempt to steal your vehicle, but it's possible that radio interference has drowned out the signal. This is a straightforward issue to fix.
If your key fob is not being recognized by the system, you can try a new battery. Also, make sure that the battery is of the correct size and type. Batteries of the wrong size could damage your battery.
Certain alarm systems and radar detectors use the same radio frequency as your key fob, and this could cause them to interfere with your key signals. Beware of attaching these devices to your key fob.
Pairing Issues
A car's remote keyless entry system contains an antenna that receives radio frequency signals from the key fob. You won't be able to start your car if this receiver is malfunctioning, even if your key fob is functioning and is reprogrammable. The issue can be caused by a range of causes, including a dead coin battery and water damage. peugeot car key could also be malfunctioning as a result of an internal or software issue or damage to the key itself.
One of the most common reasons for why your Peugeot 308 key fob doesn't work is that the battery inside has gone out of service. This battery can be easily replaced, but you must ensure that it's the right battery for your keyfob. It is recommended to use one that is the same size as well as voltage and specifications as the original.
Another reason why your Peugeot 308 key fob might not be working is that it is connected to an unrelated vehicle. This could be the case if you have given your key fob to a friend or when the key has been used to unlock and start other vehicles. You can fix this by reprogramming your key fob using an OBDII scanner. The tool will ask you for details about your car including its VIN or engine type. It is vital to enter the correct information.