15 Astonishing Facts About Fiat 500 Replacement Key Cost
Fiat 500 Replacement Key Fob
It could be time to replace the battery if the 500 remote key fob is not working. If you replace the battery, but it doesn't work it could be the issue somewhere else.
United Locksmith specializes in the production of new keys for classic vehicles. We have all the necessary tools and parts to provide this service.
Dead Coin Battery
A dead battery is the most frequent cause of your Fiat 500 keyfob not locking or unlocking the doors. The battery of the coin cell inside the key fob is likely to drain quickly if you don't use frequently enough. If your remote began to show signs of weakness such as a loss in range and then completely stopped working the battery could be dead.
Metal clips keep the battery securely on the key fob. If the clips aren't tightly secured, they could result in problems with the contact, which can stop the remote from receiving power. Using a small flathead screwdriver, push the retaining clip outwards to remove the battery and replace it with a new one. Make sure to use a battery with the same voltage, size and specification as the original.
The exposure to water can cause the key fob to corrode, or even become damaged. Even a small bath in soapy water may damage the electronic chip inside. Keep your key fob dry.
Water Damage
Water damage may be the reason for your key fob not working properly. Key fobs have rubber seals that stop them from being damaged by a light rain or splashes of water, but it is essential to keep your keys safe from the pool, ocean and the washing machine!
The key fob is equipped with an electronic chip which sends an alert to the immobilizer system of your vehicle. The chip allows the 500 to start and lock. If it gets wet it will cease to work.
You can clean the inside of your key fob's electronics using isopropyl alcohol, or an electronic cleaner to see whether they're still in good condition. It is best to replace a key fob in the event that it has been submerged into salt water rather than attempting to repair it yourself.
A replacement fob can cost you a little bit, but it's a lot cheaper than having to have your Fiat 500 towed to a dealership and repaired there! Plus, you can make it yourself in just only a few steps. Make sure you have the correct battery type before you attempt to open your key fob. You can find step-by-step instructions for any car keyfob on the internet.
Faulty Chip
The chip inside the key fob communicates directly with the immobiliser of your car to ensure that the vehicle will only start when right keys are in place. If the chip is damaged or corrupted in any way your car will not start.
Damage to the water or a dead cell battery are the most frequently cited reasons for defective chips. Whatever the reason, it is recommended to delegate the work to a locksmith as they will be able to repair the chip for you swiftly and at an affordable price.
If your key fob will not work after exposure to clean tap or rain water then remove the battery. Clean the electronic component using paper towels. If mouse click the following internet site will not function, there is the possibility that it's malfunctioning components and need to be replaced.
Some people will go to their dealer when they require a new Fiat fob. However, this could be costly. United Locksmith is the best place to go if you would like to have your Fiat keyfob fixed at a reasonable cost. We have the tools and experience needed to repair your Fiat key fob in a timely and professional manner.
Faulty Receiver Module
Fiat key fobs send signals up 50 feet to the vehicle, which will unlock and close the doors (and start the vehicle for those with automatic transmissions). However there are a few factors that can cause the fob to stop functioning. This could be due to a dead battery water damage, worn out buttons, a receiver issue, signal interference or malfunctioning chips.
If the fob is in a pocket which has suffered extreme trauma (such as being dropped on a hard floor or being washed in the washer), it may not be in a position to connect with the Body Control Module (BCM) of the car. The BCM is a security device that can only accept signals from genuine keys.
You will need to replace the fob in case this occurs. A professional locksmith can take care of all aspects of the replacement procedure and even program a new one for the 500. In fact, they'll offer you a clone key that functions exactly the same as your original fob (and costs only a fraction of the price).