14 Creative Ways To Spend Extra Peugeot 308 Key Fob Budget
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a bit however, it's still appealing. It's not the most luxurious car in its class It's the Ford Focus or Volkswagen Golf will protect you from imperfections on the road - however, it's a comfortable and pleasant drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fob s. Whether the problem is persistent or intermittent the following suggestions should assist.
Water Damage
If you leave your fob in a puddle or splash it with water while kayaking, swimming canoeing, rafting, or canyoning, it's most likely to suffer water damage. Keep your key fob in a dry bag whenever you are outdoors or engage in activities that expose it to excessive water.
You'll also want to ensure that the fob is completely dry prior to opening it and using it again. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) This is a further sign that it has been submerged.
A circuit board that's wet can cause the battery to dump its charge, or even explode. If you're able fish your 308 key fob out of whatever body of water it was stuck in, flip the button side down and shake out as much water as you can before opening the case. Once you have opened it, remove the battery and wipe down the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might not function include a dead battery for your coin or receiver module issue, signal interference, or an electronic chip malfunctioning. If none of these are the problem, you can try resetting the system by removing the 12 volt battery for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology that lets drivers start their vehicle from the distance, allowing them to warm up or cool down the car before they enter. This feature is extremely useful, especially during cold winter months. However, it is possible that the remote stop system stops operating due to a range of causes, such as the battery in the coin is dead.
The coin-shaped battery contained inside the key fob can last between two and four years, based on the frequency with which it is used, the location it was purchased and how it is utilized. The date for use-by will be displayed on the packaging or mentioned in the user manual.
If the key fob stops working after being exposed clean tapwater, remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to become damaged. You will need to replace it.
If you're not sure whether the battery is defective you can check its voltage using an instrument connected to the terminals plus and minus. The voltage should read approximately 12-13 volts, but if it's lower, the battery must be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible the receiver module has developed a fault. It's the part that sends a signal to the car when your key fob is activated, it also acts as an immobiliser and prevents it from starting unless the correct key is present.
This could be caused by many causes, such as water damage or just the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, like the chip that is located inside may be damaged. In this scenario you'll have to take the device apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue isn't resolved then it's a good option to consult an area Peugeot specialist or locksmith. They will be able to utilize a diagnostic tool to help pinpoint the issue and repair it for you.
It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can address the problem in minutes. They can cut a brand new key and program it to your vehicle, ensuring that you can get back off the road in the shortest time possible. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip inside the Peugeot 308 key fob plays a crucial function in the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying "anti-theft". In this scenario the only option is to replace the key. Auto locksmiths who are professionals can provide this fastest possible time.
The chip inside your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other causes. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned immediately. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to dry completely.
Radio interference can cause a key fob to stop working. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It could be caused by poor conditions or objects close to the vehicle. It is recommended to visit a Peugeot dealer if you experience this issue.
The Peugeot Key Fob 207/308 is fragile and requires particular care. It is imperative not to throw or drop the key fob. If you lose it, try to find it as quickly as possible. You can reset your on-board computer by disconnecting the battery for a few minutes. Unplug the negative cable prior to the positive.