11 Strategies To Completely Redesign Your Fiat 500 Replacement Key Cost
Fiat 500 Replacement Key Fob
If your remote key fob isn't working, it might be time to replace the battery. However, if you replace the battery and it does not work, then the problem may be elsewhere.
At United Locksmith, we specialize in the creation of new keys for old cars. We have all of the tools and parts necessary to perform this service.
Dead Coin Battery
A dead battery is the main reason for your Fiat 500 keyfob not locking or unlocking the doors. The key fob has an in-built battery that is prone to draining quickly if it is not utilized frequently enough. If your remote starts to show signs of loss of range or has stopped working and the battery is not working, it could be dead.
The battery inside the key fob is held in place by steel clips for retaining. If the clips are not tight, they can create problems with the contact, which can stop your remote to receive power. Use a flathead screwdriver to pry open the retaining clip and remove the battery. Make sure to use a battery with the same size, voltage and specifications as the original.
The key fob can be damaged or corroded through exposure to water. Even a brief bath in warm, soapy water could cause damage to the chip. Keep your key fob dry.
Water Damage
If your key fob isn't operating properly, it could be caused by water damage. The rubber seals on key fobs keep them from getting damaged by a slight drizzle or splash of water. However, it is crucial to keep your keys of your car away from the washing machine, the ocean and pool.
The key fob contains an electronic chip that transmits a message to the immobilizer of your car. The chip is what allows the 500 to lock and start. If it gets wet, however, it will no longer function.
You can try cleaning the internal electronics of your key fob using isopropyl alcohol or an electronic cleaner to determine whether they're still working. However, it is probably better to purchase a replacement from a dealership instead of trying to fix a key fob that was submerged in salt water.
While a replacement fob could cost a bit of money, it is far less expensive than having to pay for your Fiat 500 to be towed to the dealer for repair! You can also do it yourself by following only a few steps. Be sure to have the correct battery type before you attempt to open your key fob. You can find step-bystep instructions for any key fob in your car online.
Faulty Chip
The chip inside the key fob communicates to your car's immobiliser system to ensure the vehicle is able to start when the correct key is inserted. If the chip is damaged, or damaged in any way your car will not start.
Damage to the water or a dead battery are the two most common causes of the chip being damaged. It is best to hand over the job to a professional locksmith who can replace the chip in a short time and at a reasonable cost.
If your key fob stops functioning after exposure to clean water from the tap or rain, take off the battery and wipe down the electronic component with a towel to ensure it's dry before putting it back in. If the key fob fails to work it's most likely a fried chip and will require replacement.
Some people go to their dealer in order to get an entirely new Fiat fob. However, this can be a costly option. If you're seeking a cost-effective method to get your Fiat key fob repaired Look no further than United Locksmith. We have the tools and knowledge needed to repair your Fiat key fob in a timely and professional way.
Faulty Receiver Module
Fiat key fobs send an electronic signal to the vehicle which will unlock and lock doors (and start the vehicle for those with an automatic transmission) up to 50 feet. However there are some things that could cause the fob to cease working. This could be due to a dead coin battery, water damage buttons, worn ones and a receiver module issue, and signal interference or an electronic chip that is malfunctioning.
If the fob is stored in a place that has suffered a severe trauma, such as being dropped on a hard floor or being washed in the washing machine, it may not be capable of communicating with the car's Body Control Module (BCM). The BCM is a security device that will only accept signals from genuine original keys.
It is necessary to replace the fob in case this happens. fiat 500 key can handle all aspects of the key replacement process and can even program a brand new one for the 500. They can even offer an clone fob that performs the same as the original (and costs only a fraction of what it would cost).