10 Wrong Answers To Common Peugeot 308 Key Fob Questions Do You Know The Right Answers?
Peugeot 308 Key Fob Replacement
Peugeot's 308 is somewhat old-fashioned, but it is still attractive. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can assist whether the issue is constant or intermittent.
Water Damage
If you accidentally drop your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it's likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry, dry bag when you're outdoors or performing activities that require the fob to be exposed to excessive amounts of water.
You should also ensure that the fob is dry before opening it up and reusing it. If you notice any odors coming from the fob, such as an industrial-type liquid smell or that of windshield washer fluid, it's another sign that it's submerged in water.
A circuit board that's damp can cause the battery's charge to drop its charge, or even explode. If you can get the 308 keyfob from the water, turn the button side up and shake as much water as you can prior to opening the casing. After opening it, remove the battery, and then clean the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system may be unable to function could be due to an empty coin battery or receiver module issue, signal interference, or an electronic chip that is damaged. If none of the above are the reason, you may try resetting the system by disconnecting the battery that is 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system which allows the driver to start the car from afar while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely helpful, especially during cold winter months. The remote start system can stop working for a variety reasons, including the battery being dead.
A coin-shaped battery that is located inside the key fob has a lifespan of two to four years, depending on how often it is used and where it is purchased. The date of use is typically found on the packaging or listed in the instruction manual.
If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. You will need to replace it.
If you're unsure whether the battery is defective, you can check its voltage using an instrument connected to the minus and plus terminals. If the voltage is lower than 12-13 volts, then it is time to replace the battery. You can also attempt to reset the onboard computer by disconnecting the 12 volt battery for a couple of minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should now start.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has discovered a problem. It's the component that transmits an alert when the key fob goes off. It also functions as an alarm, and stops the car from starting without the correct key.
This could result from a variety of causes including water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the chip that is located inside the device will be damaged. In this situation, you'll have to remove it and clean it thoroughly using isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue persists, it is a good idea to consult an area Peugeot expert or locksmith. They can use the diagnostic tool to pinpoint the problem and then fix it.
It can be stressful to lose your Peugeot car key. A qualified auto locksmith will be able to resolve the issue within minutes. They can program your vehicle and cut a new working key for you. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you could experience difficulties starting your vehicle or receive a message saying "anti-theft". In this scenario, the only solution is to replace the key. replacement key for peugeot expert van are able to offer the service within the shortest possible time.
The chip in your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other causes. If your Peugeot key fob has been exposed to soapy or dirty water, it needs to be cleaned right away. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to completely dry.
Sometimes the key fob may stop working because of radio interference. This is usually caused by other devices use the same frequency as your Peugeot keyfob. It could be caused by poor conditions or objects close to the vehicle. If you experience this issue it is advised to visit an Peugeot dealership.
The Peugeot 207/308 key fob is extremely delicate and requires extra care. It is crucial not to throw or drop the key fob. If you lose something, try to locate it as soon as you can. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable before the positive.