10 Quick Tips About Peugeot 308 Key Fob
The Key Lab could be catching on a little, but it still feels attractive. It might not be the most luxurious car in its class and it's a Ford Focus or Volkswagen Golf will protect you from road imperfections, but it's a relaxing and comfortable drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. The following tips will help whether the problem is persistent or intermittent.
Water Damage
If you accidentally drop your key fob in an eddy, or it gets wet while kayaking, canoeing or rafting or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry container when you're going outdoors or doing things where the fob might be exposed to high levels of water.
It's also essential to make sure that the fob has dried out prior to opening it to use it again. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) This is a further sign that it has been submerged.
A wet circuit can cause the battery's charge to drain or even explode. If you're able to fish your 308 key fob out of the water in which it was stuck in it, flip the button side down and shake out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board clean using a cotton swab which has been dipped in 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell, receiver module problems signal interference or a malfunctioning chip. If none of the above are the problem you can restart the system by disconnecting 12 Volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start systems which allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the car before they get in. This feature is very useful, especially in the cold winter months. The remote start system may cease to function for a variety reasons, including an inactive coin-battery.
The coin-shaped battery located inside the key fob could last between two and four years, based on the frequency with which it is used, where it was purchased and how it is used. The use-by date will be printed on the package or in the user manual.
If the key fob stops working after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it could have fried the chip. It is necessary to replace it.
If you're not sure whether the battery is damaged it is possible to check its voltage using a multimeter attached to both the terminals for plus and minus. The voltage should be around 12 to 13 volts, but if it is lower, the battery must be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.
Faulty Receiver Module
If you aren't seeing the "Key Detected" It could be that your receiver module is defective. It's the component that sends out an alert when the key fob activates. It also acts as an alarm and blocks the car from starting if you don't have the correct key.
The cause could be a number of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, like the chip that is located inside the device will be damaged. In this instance, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.
If the problem persists the issue persists, it's a good idea to see a local Peugeot specialist or locksmith. They can employ a diagnostic tool in order to identify the issue and repair it.
The loss of your Peugeot keys to your car is an incredibly stressful experience. However, a qualified auto locksmith can address the issue in a matter of minutes. They can program your vehicle and cut a brand new, functioning key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If it becomes damaged, your car might not start or you might receive a message stating "anti-theft active". In this case the only option is to replace the key. Luckily, auto locksmiths who are professionals can offer the service in the shortest amount of time.
The chip in your Peugeot 308's key fob could be damaged due to different reasons, such as sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, cleanse it immediately. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, let the battery completely dry.
Radio interference can cause the key fob to stop functioning. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. This could be due to unsafe conditions or objects that are in the vicinity of the vehicle. If you encounter this issue it is recommended to visit a Peugeot dealership.
The Peugeot 207/308 Key Fob is delicate and needs special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Be sure to disconnect the negative cable first before connecting the positive.