10 Apps To Help You Control Your Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be a bit old but it's still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is persistent or intermittent the following suggestions should help.
Water Damage
If you accidentally drop your key fob into a puddle or it is wet while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. The best way to stop this from happening is to keep it in a dry bag when you're outdoors or performing activities that require the fob to be exposed to a lot of water.
It's also crucial to make sure that the fob has dried out before you open the fob and then use it. If you detect any smells emanating from the fob like an industrial-like liquid smell or the scent of windshield washer fluid, this is another indication that it's submerged in water.
A wet circuit board can cause the battery's charge to drop its charge or even explode. If you're able fish your 308 key fob out of the water in which it was stuck in then flip the button side down and shake it out as much water as possible before opening the case. Remove the battery, then clean the circuit board using a cotton swab that is dipped in 90 percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system might fail to function include the battery of your coin is dead, receiver module issues signal interference, an electronic chip that is damaged. If none of these causes the problem, you can try resetting the system by removing the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows the driver to start the car from afar while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely useful, especially during winter's cold and chilly months. Remote start systems can be stopped for a variety of reasons, such as the dead battery in the coin-battery.
The coin-shaped battery contained within the key fob may last between two and four years depending on how often it's used, where it was purchased, and how it is used. The date of use will be displayed on the packaging or in the user's manual.
If the key fob has stopped working after exposure to water that is clean then you must remove the battery, then clean the electronic chip using a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. In the event of exposure to salty or soapy water, the chip could be damaged and you'll need to replace the key fob entirely.
If you're unsure whether the battery is defective, you can check the voltage using an instrument connected to the minus and plus terminals. The voltage should read approximately 12 to 13 volts, but if it is lower, the battery should be replaced. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start after this.
Faulty Receiver Module
If you don't see "Key Detected" It could be that your receiver module is faulty. It's the component that sends out a signal when your key fob activates. It also acts as an alarm, and stops the vehicle from starting without the correct key.
This could be caused by many factors, including water damage or just ageing. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water It could be because the keyfob was exposed it. In this situation, you'll have to remove it and thoroughly clean it with isopropyl or electronic cleaner. Once the battery has dried you can try it again.
If the problem persists it is a good idea to see a local Peugeot expert or locksmith. They'll be able utilize a diagnostic tool to assist in identifying the problem and fix it.
Losing your Peugeot keys to your car can be an incredibly stressful experience. However, a professional auto locksmith can fix the issue in only a few minutes. replacement key for peugeot partner van can cut a new key and program it to your vehicle, ensuring that you're ready to get off the road as quickly as possible. Click here to find a locksmith near you.
Electronic chip that is malfunctioning
The electronic chip that is in the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message saying "anti-theft". In this situation, the only solution is to replace the key. Professional auto locksmiths are able to offer the fastest possible time.
The chip in the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. The battery should be allowed to dry completely.
Sometimes keys can stop working because of radio interference. This can happen when other devices use the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you experience this problem.
The Peugeot 207/308 key fob is extremely delicate and requires extra attention. You should not drop it or throw it around. If you lose something, try to locate it as soon as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Unplug the negative cable prior to the positive.