Need to Buy a Mattress? Read This Before You DoWhy doesn't Angie's List rate attorneys?Landscaping: What do your neighbors do that drives you crazy?How much does it cost to be a member here?How much does it typically cost to paint a 2100 square foot house on the exterior? That's very difficult to answer without seeing the house. As one poster said, the prep is the most important part. On newer homes that don't have a lot of peeling paint, the prep can be very minimal even as low as a couple or a few hundred dollars for the prep labor. On a 100 year old home with 12 coats of peeling paint on it, then the prep costs can be very high and can easily exceed 50% of the job's labor cost.A 2100 sq ft two story home could easily cost $1000 just for the labor to prep for the paint job. That number could climb too. Throw in lots of caullking or window glazing, and you could be talking a couple or a few hundred dollars more for labor. Painting that home with one coat of paint and a different color on the trim could run roughly $1000 or more just for labor.
Add a second coat and that could cost close to another $1000 for labor. For paint, you may need 20 gallons of paint. You can pay from $30-$70 for a gallon of good quality exterior paint. The manufacturer of the paint should be specified in any painting contract. Otherwise, the contractor could bid at a Sherwin-Williams $60 per gallon paint and then paint the house with $35 Valspar and pocket the difference. $25 dollars per gallon times 20 gallons? That's a pretty penny too. That was the long answer to your question. The short answer is $2000 to $4000 and up, depending upon the amount of prep, the number of coats, the amount of trim, and the paint used. Multiple Sclerosis Centers of Excellence » Veterans » Living with MS Selecting the Appropriate Mattress for People with MS Richard Buhrer, ARNP, MSCN Why do people with MS need special mattresses? What are the various types of mattresses? What are mattress covers? Will the VA cover special mattresses? Why do people with MS need special mattresses?
Because of the problems with sensation and movement that are often a component of multiple sclerosis, people with the disease often require special mattresses to keep them safe from developing bed sores and other skin problems. Another problem that people with MS suffer from is heat intolerance. In the presence of a high ambient temperature (temperature of the inside or outside environment), the nerves damaged by MS cease to function. So that when people with MS become overheated, their ability to move and sense the environment is diminished. Choosing a mattress that will protect the individual from becoming overheated and that will provide skin protection is very important for the health of the person with MS. What are the various types of mattresses? When choosing a mattress, it is important to consider the effects of that mattress on skin protection and heat intolerance. Mattresses may be either static or dynamic. In general, a static mattress refers to a mattress that doesn’t move when a person lies on it.
A dynamic mattress is powered by electricity to change the surface under a person to allow for a variety of medical needs. Dynamic mattresses involve at least one of the following technologies: fluidized air, alternating pressure or side-to-side turning. Fluidized air therapy involves blowing warmed air through a bed of tiny silicone beads creating a surface that is like a “waterbed” but with warm air blowing up through it continuously. This type of surface is used mostly in health care institutions for patients either with very severe pressure ulcers (bedsores) or after surgery to close these wounds. Alternating pressure: Air is pumped into cylinders that are placed parallel to each other inside a mattress. As one set of cylinders inflates, the other set deflates. This way the pressure under any part of the body is relieved on a regular basis. This type of mattress can reduce the number of times a person needs to be turned while in bed. Side-to-side turning: One side of the mattress deflates and the other side inflates, alternating over time, turning the person in the bed gently from side to side.
This is normally used for patients with lung problems, but can be used for people with MS as another way to reduce the number of times an attendant must turn a person while in bed. Of these mattresses, only fluidized air is heated. The heat can be adjusted so that people with MS can use these surfaces, but they carry some risk of overheating. Alternating pressure and side-to-side turning are not heated. Therefore, heat intolerance is not as much of an issue with these mattresses. Viscoelastic or memory foam: One kind of static mattress that gets a lot of attention on TV is made of viscoelastic or memory foam (the Tempur-pedic ™). People with disabilities often find these mattresses difficult to use because they get "stuck" in a hole in the mattress and cannot move themselves out of it. Some medical mattresses are made of this substance but they do not really work out very well for people with MS. Low air loss: This involves an air sack where a small amount of air leaks through the cover on a continuous basis.
It helps to control moisture (like sweating). It provides some pressure reduction but the surface doesn't change over time and people need to be turned more frequently on this kind of surface. The air in a low air loss mattress may be heated and so this could pose problems with heat intolerance for people with MS. Air covered by foam: Another kind of static mattress is filled with air covered by foam. The air is in interwoven but not interconnected air cells that have certain stretchiness (distensibility). That way when a person lies on the bed, the air cells move and adjust to small changes in position. This kind of mattress is a good basic surface for a person who does not have a high-risk of developing bedsores. What are mattress covers? All of these mattresses (except fluidized air) have Gortex ™ covers. This is a slippery fabric that is often used to make rain gear for hiking. It allows moisture to travel in one direction (which is to say, not into the mattress) so that the mattress is protected from moisture, and bowel and bladder accidents.
It is customary to cover these mattresses with only one sheet. The goal is to minimize the number of layers between the skin and the surface of the mattress. Too many layers will increase the risk of bedsores and negate the advantages of the mattress. Gortex™ fabric reduces the friction and shear from the mattress that could also injure the skin when a person is repositioned (especially pulled up in the bed). Lying on these mattresses may feel "sweaty" and warm to the person in the bed and this can be a problem for a person with MS. The only real alternative is to control the temperature in the room where the person is sleeping by using air conditioning or fans. Will the VA cover special mattresses? The VA will only purchase single-bed sized mattresses. Most of them work best on a hospital-type bed frame. If Veterans prefer to sleep with their spouse or partner, then a good quality, soft, commercial mattress is probably the best choice. Air filled adjustable mattresses (for example, the Sleep Number Bed ™) are also available and might be a good choice for people with MS.