Ifconfig manual page
Ifconfig manual page ➞➞➞ Скачать Ifconfig manual page ======
➞➞➞ Download Ifconfig manual page ++++++
Ifconfig manual page
All 4-address traf- fic uses the security information of the stations e. To have beacons tracked in software ifconfig manual page -beacons. The interface parameter is the name of the network interface. Any other configuration parameters for the protocol should be supplied along with the vhid keyword. An example of this is to enable SLIP compression, or to select the connector type for some Ethernet cards. The options can be combined using commas. Note the sender may limit the size of AMSDU frames to be less than the maximum specified by the receiv- ing station. NOTES Since kernel release 2. This parameter is meaningful only when operat- ing in ap mode. Note the underlying device and driver must support radar detection for full DFS support to work. This option is useful when more than one access point uses the same SSID.
This can be used to label interfaces in situations where they may otherwise be diffi- cult to distinguish. The following parameters are meaningful only when WME support is in use. The -n flag disables this behavior. By default tdmaslotlen is set to 10 millisec- onds. When operating as an access point with 802. To dis- able background scanning, use -bgscan.
If a protocol family is specified, ifconfig will report only the details specific to that pro- tocol family. Note that vlan and vlandev must both be set at the same time. Note the sender may limit the size of AMSDU frames to be less than the maximum specified by the receiv- ing station. The default is 2000. These three options are interface specific in actual effect, how- ever, they are in general used to select special modes of opera- tion. Indicates that the station associated using WPS.
Ifconfig manual page
Note: for every scope i. The default port number is 4789. It happens automatically when setting the first address on an interface.
Укажите на ошибки, и над ними будет проведена работа. If the address-family is not explicitly mentioned, it would be deduced from the IP address provided along with the command if any.