Hook up hot water heater - news United States

Hook up hot water heater - news United States

Hook up hot water heater



< Hook up hot water heater < ♥♥♥ Link


< Mirror #01 < ♥♥♥ Link















































































Unheated water enters one hook up hot water heater of the tank. Then, of course, you have your hot water coming out, which will go to your faucets and your bathtubs, your sinks, your wwater, places like that. Step 13: Soldering Basics Then join the two halves of the union together place and tighten the nut firmly. If you're just putting a new tank in the same place, you'll have even less work to do. Copper is a great conductor of heat and keeping the flame in one position is all that's required to heat the entire joint. We brought new cable, from a joist-mounted junction box, to the new tank location by not holes through the middle of the overhead joists and running the cable along the side of the joists where convenient. A ground is a solid copper wire that comes out of your sleeve ho you hook it up to what's called a ground screw. We used a ball valve for this purpose but a gate valve with sweat fittings on both ends hook up hot water heater also be used. As soon as the flux disappears, touch the top of the joint with some solder. If you turn on the elements before the tank is full of water, they will be ruined and will have to be replaced. Begin by removing the tank from its box and reading all the product literature that comes with it. And then on demand the water exits from the other side of the tank. Next should be the heat source. Step 23: Electrical Power Next, measure the distance from the top of the tank up to the joists above and add about 4 in. If you have gas, install ventilation ducting. A water heater, especially an electric model, is a very simple device.
The rules are simple: The mating surfaces must be cleaned thoroughly and covered with flux, the tubing cuts have to be absolutely square and the fittings can't be bent or distorted. Step 9: Soldering Basics Once the solder starts to melt, keep pushing the solder into the joint until it drips out the bottom. Doesn't really matter which one you hook up to the other, because they're both hot wires and they're rated for a 110. All that work was well worth it!
Make sure that the open end of the valve points down.